All Car Repair Questions
Browse recent questions from the 2CarPros repair community. Use this archive to discover real-world symptoms, diagnostics, and repair discussions by vehicle.
Page 121 • Showing up to 100 questions
- Clunking feeling and noise?
- Inner tie rod removal instructions needed?
- The key keeps getting stuck in my ignition cylinder?
- I am having difficulties with my vehicle trying to start?
- Can you send me torque specs and steps on replacing oil pan gasket?
- the bellow boot is torn for the rack and pinion, instructions on how to fix this needed?
- Step by step instructions or images of how to get to the fuel rail fuel pressure sensor needed?
- Starter replacement step by step detailed instructions?
- Pull over and charge system message keeps appearing?
- Codes P1778, where are the bolts to remove from transmission valve body located?
- A/C will not go below 60 degrees and does not cycle?
- Will not start after the car sat for a few months and drained the battery?
- Replaced coded parts and car will not start?
- Rejected emissions test, vehicle OBD system is unresponsive?
- replacement manifold hose parts?
- Where is the Bluetooth Module Unit for the Handsfree Link located?
- Where is the crankshaft positioning sensor located?
- Where does the radiator core support assembly support assembly sit at?
- Leaking crankshaft seal?
- Scanner sat bank 2 sensor 1 no data retrieved?
- Instrument panel, Tachometer, speedometer, gas, and temperature gauges stopped working?
- Codes P0302 and P0306, test for bad wire to coil pack from PCM?
- Sluggish start and shaking while driving?
- Every time I turn the key to on position it blows my 40 amp fuse?
- Overheating problem?
- intermittent error on FDC and CCP?
- A/C blows cold then hot?
- Starter Relay is not getting the voltage?
- steps and torque specs for installing the power steering belt?
- What are the steps for removing the stock radio?
- process and torque specs for valve cover gasket?
- Clutch fan, never had loud noise before recent repair?
- Turn signal does not work but hazard lights do?
- Replaced the key ignition, but needs programming, how much does that cost?
- Codes P0300, P0302, VVT monitor bank 1 failure and multiple cylinders misfire detected?
- New ECM installed and it will not start?
- Truck hard to start?
- Instrument cluster lights not working in daytime?
- No start, horn and turn signals not working?
- Cam gear moved on the cam?
- Keeps burning out the VVT solenoid?
- The oil light turns on when warmed up?
- Both side Brake Light always on even switch off the engine?
- Crank no start issue after running the car out of gas?
- Where is the Inertia reset located?
- No running lights and dash light not working?
- Not running properly and oil found on one of the spark plugs, what would cause this?
- Codes, p0441, p0137, and p0420?
- Front passenger low beam headlight and turn signal not working?
- no power at the HVAC module?
- Battery light on after starter replacement?
- Overheating within twenty minutes of driving?
- Shift solenoids, are the solenoids exposed when taking off the transmission oil pan?
- Code P00ac, P00ca cranks will not start?
- Where is the starter located?
- Losing coolant and overheated, should I replace the water pump?
- Oil change, added two quarts of the wrong viscosity oil, can I use 5W-20, or do I need to drain it and use 5W-30?
- Truck shuts off when transmission is shifted into drive?
- Cutting off and rough idle, can I get a diagram for the vacuum hoses?
- When the ignition switch is turned on fuel injector negative turns to positive?
- ECU codes?
- No reverse and no backup lights activating?
- Running Lights (Tail) Malfunction?
- i need to replace my fuel pump?
- Installing a push to start and stop button, can I get a color code wiring diagram for the ignition switch?
- Push button emergency brake, can it be move?
- Overdrive not working?
- High screeching sound when I try to start it?
- Wiring diagram needed for brake, running and taillights?
- For some reason my VVT solenoid is getting no power?
- Rough idle, lost power, and it misses while driving?
- Check engine light on with codes po342 and po343, Cam and Crank shaft sensors?
- While compressing piston in rear caliper to spin it also?
- Code p216c, can I a wiring diagram for the ECU?
- No crank no start?
- Mass air flow sensor?
- Driver's side door, I cannot open the door from the inside?
- Engine vacuum lines diagram needed?
- Code P0420?
- Rear Brake and turn signal lights are not working?
- Crank no start issue after overheating?
- OBD Fuse location needed?
- Noise from front end left side, it sounds just like the front left tire is on a rumble strip on a road?
- Hole blown in head?
- Where are the Camshaft and crankshaft sensors located?
- Small leak-FRT of oil pan-looks like coolant, not oil?
- Where is the fuel filter located?
- How to remove the rear seat base instructions needed?
- Cooling fan, I purchased coolant that is a different color, will adding it cause problems?
- Gear Transfer problem?
- Code p0420, loss of power and high fuel consumption?
- Play on steering, the MOT advisory was track rod end ball joint has slight play?
- Vacuum hose fell off, will not turn on with battery charge?
- Spark plug wiring diagram needed?
- Codes P0021, P0345, U1000 and U1001, rattle noise on the engine?
- Where is the fuel tank pressure sensor located?
- Obd1 code 33?
- grinding noise even when not pushing on the brake pedal after the caliper bracket bolt came off?
- Codes 7e8 & 7e9a/t, what are they?
- Transfer case in neutral?