Mazda


1990 Mazda B2200 Replace Pads & Turn Rotars

1990 MAZDA B2200
Need Disassembly Instructions
1 ANSWER
Asked by KfrederickJr

1995 Mazda MX3 Timing Gear Alignment

1995 MAZDA MX3
I Have A Dohc 4 Cyldr 1.6l, I Need The Cam Shaft Alignment Showing The Position Markings On All 3 Gears, 2 Of Them Being The Cam Shafts, And...
1 ANSWER
Asked by homiechic

1995 Mazda MX3 Alinement Of Crankshaft

1995 MAZDA MX3
Where Are The Cam Gear Marks Suppose To Be And What Do They Look Like? ( To Replace The Timing Belt). The Waterpump Was Changed And The Cam...
1 ANSWER
Asked by homiechic

1997 Mazda 626 The Car Wont Start

1997 MAZDA 626
I Have A 1997 Mazda 626 That Turns Over Gets Fire And Fuel But Still Wont Start Any Suggestions
1 ANSWER
Asked by sdw0669

1996 Mazda MX6 Obd II Reading

1996 MAZDA MX6
Engine Performance Problem 1996 Mazda Mx6 Two Wheel Drive Automatic 75000 Miles Obd Ii Reading P1195 -egr Boost/baro Sensor Open Or...
2 ANSWERS
Asked by michael campbell

2002 Mazda Protege Ticking Under Hood

2002 MAZDA PROTEGE
Noises Problem 2002 Mazda Protege Front Wheel Drive Automatic 70000 Miles My Car Recently Started With This "ticking" Noise From...
1 ANSWER
Asked by aprilynne

1991 Mazda Truck Engin Not Running Properly

1991 MAZDA TRUCK
1991 Mazda 4x4 B2600i ,2.6 Engin . This Truck Will Crank And Run For A Few Secondes And Starts To Run Slugish And Will Die . But It May Run...
1 ANSWER
Asked by pistolt51

2002 Mazda Tribute Oxygen Sensor Trouble

2002 MAZDA TRIBUTE
I Have Replaced The Same O2 Sensor Twice And Now The Same Po136 Code Is Coming Up Again. What Are The Possible Causes Losing The Same...
1 ANSWER
Asked by tmshoem

Valve Adjustment

1986 MAZDA OTHER
I Have A Mazda B2000 And The Valves Need Adjusting, But I Cannot Find The Valve Adjustment Diagram Or Any Instructions On How To Do It To...
1 ANSWER
1 IMAGE
Asked by jwardmls

2000 Mazda Protege Car Dies When Warm

2000 MAZDA PROTEGE
This Car Has Had This Problem Pretty Much Since I Got It ~1yr Ago. It Dies After It Stays Warm For A While, Running The Heater At Full Blast...
1 ANSWER
Asked by kr4z33
Ask a new Mazda question