BMW Engine

Browse BMW Engine questions and answers. Choose a question that matches your symptoms.

2,758 discussions


Car Starts Then Immediately Stops?

2006 BMW X3
It's Been Driving Absolutely Fine, But Today As I Started It, It Began To Rev Up And Down. I Turned The Engine Off And Plugged In My Obd...
1 ANSWER
6 IMAGES
Asked by Kebirdie

Car Constantly In Limp Mode And Throttle Not...

2006 BMW 330
I Have The Car Listed Above 300i And The Throttle Not Working And Car In Constant Limp Mode. I Have Changed The Following Parts Below As...
4 ANSWERS
2 IMAGES
Asked by uzomakiy

Coil Wiring Diagram Needed?

2006 BMW 325I
Need Diagram Coil Wiring.
9 ANSWERS
7 IMAGES
Asked by Krystal92082

Fault Codes: P110D, 2D07, 2CF8

2006 BMW 118I
I Have Replaced The Throttle Body Which Has The Sensor Attached, And Replaced The Connector To The Throttle Body But Still Getting These...
1 ANSWER
1 IMAGE
Asked by Bmw_steve

A/C Serpentine Bypass Belt

2006 BMW 525I
Got The Car From An Auction, Had To Buy A Key Fob For The Car To See If It Would Start. No Serpentine Belt, All Pulleys Spin Except The Air...
1 ANSWER
1 IMAGE
Asked by Tony Gorjup

Rough Idle, Random Misfires, Power Loss And A Code...

2006 BMW 325I
Just Replaced Spark Plugs. Car Was Overheating Before But I Replaced Thermostat Water And Radiator The Problem Went Away.
1 ANSWER
Asked by Bcano

New Engine Will Not Start Code P0335

2006 BMW 330
I Changed The Engine And Once It Put Into The Car It Started And Stop. When I Checked The Where No Injection Pluse And No Spark Then I Scan...
18 ANSWERS
3 IMAGES
Asked by Uzomakiy Okpala

New Engine Will Not Start

2006 BMW 330
The Car Still Won't Start And Give P0335 Error Code. I Have Changed 4 Crankshaft Sensor And Still It Won't Start. I Even Got 2...
14 ANSWERS
3 IMAGES
Asked by Uzomakiy Okpala

Needle Goes Up And Down When Comes To Stop Or Park

2006 BMW 325I
My Vehicle Listed Above Ia An Xi Model. Needle Goes Up And Down When Comes To Complete Stop Or When In Park. This Only Happens When The...
6 ANSWERS
Asked by Sebastian Prenevost

Eccentric Shaft Sensor Seal Replacement Does Not Fit

2006 BMW 325I
I Have The Car Listed Above 325xi E90. I Replaced The Valve Cover Gasket And I'm Replacing The Eccentric Shaft Sensor Seal That Sits On...
1 ANSWER
1 IMAGE
Asked by Sebastian Prenevost

Browse other repair topics

Browse by repair topic
SymptomsAir FilterAir Intake Temperature SensorAir Intake TubeBalance ShaftBlockCamshaftComputerCoverCrankshaftCrankshaft PulleyCylinder HeadTickEstimateFlywheelGround StrapHarmonic BalancerIdle Air ControlIntake ManifoldInterchangeKnockMAP SensorMass Air Flow SensorMountOil LeakOil ChangeOil CheckOil CoolerOil Fill CapOil FilterOil Level SensorOil PanOil Pressure SensorOil PumpOxygen SensorPistonRebuildReplace/RemoveSerpentine BeltStarterSuper ChargerThrottle BodyTiming BeltTiming ChainTune-upTurboVacuum Hose DiagramWiring

    Can’t find your issue?

    Ask a new BMW question