SPINDLE NUT Questions

Spindle Nut Missing

2003 FORD E-SERIES VAN
Heard A Pop-like Noise While Turning Around With Wheel Fully Turned. Shortly After That, The Front Passenger Wheel Basically Was Wobbling On...
10 ANSWERS
2 IMAGES
Asked by sbauer

How To Remove The Front Spindle Nut (hub Nut) To...

1997 HONDA ACCORD
How To Remove The Front Spindle Nut (hub Nut) To Replace Rotors? Do I Need A Special Tool? If So Can I Rent It?
1 ANSWER
1 IMAGE
Asked by TonyNeal

Hub Assembly Missing Spindle Nut

1996 FORD BRONCO
I Recently Had The Ball Joints Done And The Shop Forgot (lost) To Put A Part Back In My Hub Assembly. I Believe. The Spindle Nut Lock Is Not...
3 ANSWERS
2 IMAGES
Asked by Calvink22

Front Spindle Nut

2005 FORD F-150
When Tightening Spindle Nut To 295 Ft. Lb. Spec. Rotor Locks Up.
4 ANSWERS
2 IMAGES
Asked by gary1399

1994 Nissan Maxima Spindle Nut Removal

1994 NISSAN MAXIMA
I Want To Remove The Rear Right Hub On The Above Car To Replace A Lug Nut. I Removed The Dust Cap And The Cotter Pins But The Spindle Nut...
1 ANSWER
Asked by ourses

2002 Acura TL Spindle Nut On Rotor

2002 ACURA TL
Replacing My Brakes And Rotors And I Cannot Get The Spindle Nut Off Of The Front Of The Rotor To Slip It Off. Any Tips To Remove The Nut...
1 ANSWER
Asked by dafaught

2005 Dodge Caravan Spindle Nut

2005 DODGE CARAVAN
I Need To Change My Front Rotors On My 2005 Grand Caravan. Can The Spindle Nut Be Re-used? The Autozone Website Indicates That It Needs To...
1 ANSWER
Asked by nc_crawford

I Have A 1999 Dodge Dakota 5.9L Engine And I Am Trying...

1999 DODGE DAKOTA
No Matter Which Way We Try Its As If It Were Bolted On, What Should I Do? We Even Tried Putting The Crowbar In Between The Bolts And Nothing...
3 ANSWERS
Asked by patty02

What Is The Best Way To Loosen The Hub/spindle Nut To...

2003 HYUNDAI SANTA FE
Have Been Trying To Loosen This Nut, Using Wd40, Is It Safe To Use Heat? What Can We Do To Get This Nut Off Of The Car?
2 ANSWERS
Asked by keithrondon

2002 Honda Accord Rear Axle Hub Spindle Nut

2002 HONDA ACCORD
2002 Honda Accord I'm Doing Brakes On This. Is It Necessary To Use A New Spindle Not On The Hub? I Think I Can Wedge The Staked Part...
1 ANSWER
Asked by 1cm2