What is the best way to loosen the hub/spindle nut to access the cv joint

2003 HYUNDAI SANTA FE
Avatar
KEITHRONDON
  • MEMBER
  • 1 POST
Have been trying to loosen this nut, using WD40, is it safe to use heat? What can we do to get this nut off of the car?
Dec 18, 2011 at 4:23 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
RASMATAZ
  • CAR REPAIR CONTRIBUTOR
  • 75,992 POSTS
I'll use heat, WD40 and hit it with an impact wrench
Dec 18, 2011 at 4:35 PM
Advertisement
Avatar
WRENCHTECH
  • CAR REPAIR CONTRIBUTOR
  • 20,761 POSTS
I would be very careful with the heat if you are not planning on replacing the hub bearing. A strong impact gun is usually all that is needed.
Dec 18, 2011 at 5:18 PM