REPLACE/REMOVE CAMSHAFT SENSOR Questions
1996 Chevy Truck
Computer Problem
1996 Chevy Truck V8 Two Wheel Drive Automatic
Hi I Have Replaced My V6 For A V8 In A 1996 Silverado Now My Pick Up...
Asked by inguesu
1999 Ford F250 Cam Sensor
I Changed Out My Cam Sensor Because It Started Dying. It Runs Good Now Except When It Is Damp. Even When It Is Fogy The Engine Will Die And...
Asked by rking3
94 2.2l Swaped Into A 96whole S10
I Replaced My 96 2.2 With A 94 2.2l Swaped All The Sensor To Factory Every Sensor Pluged Up With No Plugs On Harness Left Getting Spark Fuel...
Asked by kjheauser
2000 Dodge Stratus Died While Driving
I Was Driving And My Dodge Shut Off And Could Not Get It Cranked. If You Were To Turn The Key It Will Turn Over But Not Crank. The Cam Shaft...
Asked by terbar11
Cam Sensor
I Have A Cam Sensor That Fails When It Gets To A High Temperature. I Have Replaced It But Now The Car Will Not Even Start. When I Put The...
Asked by Paul Grinter
Shifting Issues?
I Guess I Need To Give Full Details In Order For You To Give A Better Diagnosis, This Will Be Long But Here I Go, Last Year My Apts Had My...
Asked by Dc Crenshaw
2001 Pontiac Grand Am Big Problem
I Change Ingition Module The Cranck And Cam Sensor One Ingntion Coil And The Car Make Backfire A Diconect A One Wire Cilnder 3 Or 1 The Car...
Asked by carlos2234
What Is The Ignition Advance Supposed To Be On A 02...
I Changed The Timing Belt Crank Sensor And Camshaft Sensor About 9 Months Ago And Lately The Car Has Been Falling Flat On Its Face Under...
Asked by vicsgarcia
Check Engine Light On Car Will Start & Run. Error Code...
Check Engine Light On Car Will Start & Run. Error Code Points To Cam Shaft Sensor Replaced Sensor Twice Will Not Start With New Sensor Put...
Asked by Anonymous
It Wont Start, Just Turn Over, Change Ecm, Crank And...
It Wont Start, Just Turn Over, Change Ecm, Crank And Camshaft Sensor, Ingnition Module
Asked by Anonymous
