I am trying to change the crank position sensor on my 97 jeep cherokee laredo,120000 miles 4.0 liter.Where is it located?
Sep 20, 2007 at 4:32 PM
crank position sensor
JEEP CHEROKEE
TLMONEY
- MEMBER
- 2 POSTS
Advertisement
BMRFIXIT
- ✓ASE Certified Mechanic
- 19,053 POSTS
[quote:4973bb99b7="tlmoney"]I am trying to change the crank position sensor on my 97 jeep cherokee laredo,120000 miles 4.0 liter.Where is it located?[/quote:4973bb99b7]
bell housing driver side upper side
bell housing driver side upper side
Sep 20, 2007 at 4:35 PM
RASMATAZ
- ✓ASE Certified Mechanic
- 75,992 POSTS
Its on the transmission bellhousing unless is no good for references-
Sep 20, 2007 at 4:36 PM
WRENCH
- ✓ASE Certified Mechanic
- 57 POSTS
Try left rear engine by the trans bell housing area, its a big pain to get too, sorry.
Sep 20, 2007 at 4:46 PM
[quote:0d14fdd99b="rasmataz"][quote:0d14fdd99b="tlmoney"]I am trying to change the crank position sensor on my 97 jeep cherokee laredo,120000 miles 4.0 liter.Where is it located?[/quote:0d14fdd99b]
Its on the transmission bellhousing-[/quote:0d14fdd99b]
Thank You!!!!!!
Its on the transmission bellhousing-[/quote:0d14fdd99b]
Thank You!!!!!!
Sep 20, 2007 at 6:18 PM
RASMATAZ
- ✓ASE Certified Mechanic
- 75,992 POSTS
You are most Welcome and feel free to invite friends to visit 2carpros pertaining auto repairs.
Sep 20, 2007 at 6:24 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.