1996 Honda Accord transmission gasket

SATURNTECH9

MECHANIC
30,869 POSTS

Not familiar with that one I have a OTC gensyis its really nice but not cheap. It can activate transmission solenoids etc. You really need to do a transmission pressure test. So you still don't have any codes setting in the computer?

SPONSORED LINKS

Was this

answer

helpful?

Yes

Thursday, November 28th, 2013 AT 9:05 PM

ZEMORZEMOR

MEMBER
486 POSTS

Before I measure transmission pressure line I checked the car sensor the values are:
Absolute throttle position :9.4% closed throttle 88.2% fully open throttle
Load 25.1%
Ignition timing:14 degree to 15 Degree
Intake manifold pressure:3.5 to 3.8 psiA
short term fuel 3.91 to 4.6%
Long term fuel: 0.78%
coolant temp:186.8 degree
intake air temp116.6 degree

the engine was at operation temp

is there anything wrong with these sensors?

Was this

answer

helpful?

Yes

Sunday, December 1st, 2013 AT 12:15 PM

SATURNTECH9

MECHANIC
30,869 POSTS

The only sensor that would really make it shift hard would be the throttle position sensor. Were the thrittle position sensor readings with it runninh?Did the okd transmission shift hard?

Was this

answer

helpful?

Yes

Sunday, December 1st, 2013 AT 2:10 PM

ZEMORZEMOR

MEMBER
486 POSTS

I run the engine to operation temp than I check the throttle position sensor I used a software( installed it in computer laptop) that came with the ELM327 cable. The old transmission was shifting hard too. However when I took off hard from a stop sign I do not feel the transmission shifting it shifts better that when I took off slowly.

Ok I have another question does a bad engine mount make transmission shifting hard the front engine mount is split

Was this

answer

helpful?

Yes

Sunday, December 1st, 2013 AT 2:39 PM

SATURNTECH9