Mazda Transmission
Browse Mazda Transmission questions and answers. Choose a question that matches your symptoms.
698 discussions
Transmission Acts Like Its In Neutral
Why Does My Car Drive For About A Half A Mile But Then The Transmission Acts Like Its In Neutral..but If I Shut It Off For A Few Minutes It...
Asked by cowboysrba
Dislodged The Clutch Pivot Fork
I Have Changed The Slave Cylinder On The Clutch And Have Dislodged The Clutch Pivot Fork. Can I Fix This Without Removing The Bell Housing...
Asked by rob rowles
What Should Be The Problem With My Car Mazda Familia...
Every Morning When I First Start It, It Seems Ok But After 5 To 15 Minutes The Engine Stops And When I Crank It Again It Doesnt Start...
Asked by xbabaran
Clutch Noise
When I Put My Foot On The Clutch It Is Normal..when I Go To Take Off There Is A Squeaky Sound Coming From The Engine (not The Pedal) Seems...
Asked by rustytwo
1997 Mazda 626 Vehicle Speed Sensor Malfunction
I Have Vehicle Speed Sensor Malfunction.replaced Sensor Cleared Code Vehicle Still Not Shifting Correct What Else Could Be Problem?
Asked by dixieborn76
1997 Mazda Protege Transmission Is Stuck In Park
I Have A 1997 Protege Lx 1.5 W/auto Trans. Here's The Story - I Parked The Car In June, It Worked Just Fine. I Go To Start It Up A Month Or...
Asked by soytnly
1997 Mazda 626 1997 Mazda 626 Es Wont Go Into 3rd And...
I Have A 1997 Mazda 626 Es That Will Not Shift Into 3rd Or 4th Gear, Sometimes It Will Hard Shift Into 3rd But It Revs Up To 4 Or 5 Rpms...
Asked by taylorr01234
1997 Mazda 626 Clutch Replacement
Drive Train Axles Bearings Problem
1997 Mazda 626 6 Cyl Manual 180000 Miles
Over The Last Week Or So, I Have Been Having Trouble When...
Asked by beefykins
1997 Mazda 626 Transmission Speed Sensor Replacement
Engine Performance Problem
1997 Mazda 626 4 Cyl Front Wheel Drive Automatic
The Code Says That The Speed Sensor Is Bad. How To Replace...
Asked by micar
1997 Mazda Protege Clutch Master Cyclinder
Is My Clutch Master Cyclinder Going Bad Because I Just Replaced A Slave And It Seems Like When I Shift Its Not Buiding Up Enough Pressure To...
Asked by tlebo
Browse other repair topics
Can’t find your issue?
Ask a new Mazda question
