dislodged the clutch pivot fork

1997 MAZDA B2600
Avatar
ROB ROWLES
  • MEMBER
  • 1 POST
I have changed the slave cylinder on the clutch and have dislodged the clutch pivot fork. Can I fix this without removing the bell housing?

i have just replaced the slave cylinder and now the clutch the pivot fork won't pressure back on the slave cylinder pin
Mar 31, 2012 at 10:26 PM
Advertisement
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,814 POSTS
That would depend on what had been dislodged. Remmove the slave cylinder and try wiggling the fork. You should not move the fork too far towards direction of slave cylinder. If the fork becomes free and can be moved forward or backwards, then it is oggd, if not you would have to remove the trans to reinstall.

While wiggling, do not force it to avoid the holding spring clip coming undone.
Mar 31, 2012 at 10:36 PM
Avatar
KHLOW2008
  • ✓Experienced Mechanic
  • 41,814 POSTS
Remove the dust cover at the clutch fork and see if you can peer into it and check what is wrong with the aid of a pen light.
Mar 31, 2012 at 10:37 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.