GMC Climate Control
Browse GMC Climate Control questions and answers. Choose a question that matches your symptoms.
943 discussions
HVAC No Power
Have No Blower Motor On Any Speeds, All 3 Fuses Are Good, No Power At Heater/ac Fuse, But Fuse Is Good.
Asked by Scott Gartner
Blend Door Motor Location
I Have The Suv Listed Above That I Have A Constant Clicking In My Dashboard. Already Tried The Reset Does Not Work. Looking For The Actuator...
Asked by AJcustoms
Blower Motor Not Working Properly
The Blower Motor Does Not Come On When In The Dash. But If You Take It Out Of Place Still Plugged Up And Turn Key On It Will Kick On. Could...
Asked by 8989
Low Reading On High Side During Recharge
Evacuated The System After Changing Compressor Orifice,and Drier. Started Charging The System But High Side Never Went Past 48 Lbs. Flushed...
Asked by Jws1988
No Air From The Vents?
Hello, This Is Two Problems That Do Not Happen Concurrently But I Suspect They May Be Interrelated So I Have Included Them Both. The Vehicle...
Asked by dlfrymark
No A/C But The Pressure Is Good
The Ac Started Only Blowing Cold Intermittently A Couple Of Days Ago. I Hooked My Gauge To It And It Said It Was "low."
Today I...
Asked by cannon1349
Mode Door Actuator Replacement?
I Have An Auto Hvac System. My Mode Door Actuator Does Not Seem To Be Working (no Matter What Position The Digital Display Indicates...
Asked by VoodooBoom
Rear Heat Was Not Working, But It Only Blows Cold Air
Rear Heat Was Not Working, But It Only Blows Cold Air. Replaced Hvac Module With Same Results. Manually Turned The Actuator And Heat Worked...
Asked by Faraz Ahmed
Defrost Only
Air Only Blows Through Defrost Regardless Of What Is Selected. Do You Have A Specific Video For This Repair?
Asked by Mark McCain
Replacement Of Left Blend Door Actuator
How To Replace Left Bend Door Temperature Actuator?
Asked by Matjd1016
Browse other repair topics
Air ConditionerBlend Door ActuatorBlower FanCabin FilterCodesComputerControl PanelDefrosterDuctHVAC vacuum diagramHeaterNot WorkingOne SideVentWiring
Can’t find your issue?
Ask a new GMC question
