Ford Ignition Switch

Just Put A New Battery In My Bronco. Tried To Start It. Turned Over A Couple Of Times Then Everything Died. No Lights Or Anything. Nothing...

After Sitting Over Winter I Charged Battery To Start. Have Power For Accessorys Turn Key Not To Start Hear A Click And All Power Goes Dead...

Sometimes When I Put The Key In To The Swich To Start It Up And Turn The Switch All The Way Once It Starts Let Off The Switch It Goes Dead...

So I Just Got Done Wireing A New Tachometer And Tested It And Noticed That The Engine Will Run As Long As The Key Is Held In The Run...

I Have A 1968 Gt Fastback That Has Been A Total Resto-mod With Everything New Under The Hood, All New Wiring From Battery (now In Trunk)...

About 1/2 Of The Time When I Turn The Key In The Ignition Switch To The Start Position Nothing Happens And There Is No Sound. I Will Hear A...

So I Took Off The Original Ignition Switch And Cylinder Off My Car, As I Try To Put It Back Together The Cylinder Will Not Go All The Way In...

My Ranchero Runs Good But When You Drive It And It Warms Up It Starts Fluttering Going Down The Highway. The Other Day Put On Fuelpump Went...

I Picked Up A Non Running Project. I Got The Engine To Start But Only If I Use A Screw Driver To Jump The Positive Terminal And The "s"...

My Switch Fell Apart. Dont Know How To Remove Cylinder From Dash. Any Advise?