Chevrolet Crankshaft

Browse Chevrolet Crankshaft questions and answers. Choose a question that matches your symptoms.

350 discussions


1996 Chevy Truck Rear End Locked Up

1996 CHEVROLET TRUCK
The Rear Main Seal Has Been Leaking For A While. The Other Day I Noticed That The Leak Had Stopped. A Couple Of Days Later I Went To Drive...
1 ANSWER
Asked by carl1517

1996 Chevy Monte Carlo Engine Trouble

1996 CHEVROLET MONTE CARLO
After 20 Miles Or So My Engine Stumbles Bad, Then Dies And Won't Restart For Hours. The Check Engine Light Comes On And Displays The Code...
2 ANSWERS
Asked by jimski

Where Is The 7X Crankshaft Position Sensor Located?

1995 CHEVROLET MONTE CARLO
Location Of 7x Camshaft Position Sensor For The Car Listed Above Z34 3.4l Dohc, Not The One That Goes Near The Harmonic Balancer. My Car...
1 ANSWER
3 IMAGES
Asked by Dwl92

Where Is The Crank Sensor Located?

1995 CHEVROLET CHEYENNE
Engine Turns, No Spark, No Fuel. Just Replaced Plugs, Wires, Cap, Rotor, And Coil.
5 ANSWERS
1 IMAGE
Asked by Silversac

Output Shaft Seal Replacement Instructions Needed

1995 CHEVROLET CHEYENNE
I Got A Leak At My Rear Seal Y'all Got Any Instructions/videos On How To Replace It?
3 ANSWERS
1 IMAGE
Asked by Jdub2009

Location Of The Crank Shaft Position Sensor Needed

1995 CHEVROLET 1500
Most Sources I Found Said The Crankshaft Position Sensor Is Located In The Front Of The Engine By The Crankshaft Pulley But There Is Nothing...
1 ANSWER
5 IMAGES
Asked by Scott Galvin

Crankshaft Sensor Location

1995 CHEVROLET TAHOE
Trying To Locate The Crankshaft Sensor Location On This Motor. They Sell The Sensor At The Local Auto Parts Store, But The Chevrolet Dealer...
14 ANSWERS
1 IMAGE
Asked by Tom Haydon

1995 Chevrolet Blazer 6 Cyl, 4 WD 4.3 Lt V.I.N...

1995 CHEVROLET BLAZER
1995 Chevrolet Blazer 6 Cyl, 4 Wd 4.3 Lt V.i.n 1gndt13w4s2258048 I Have Open The Upper Intake Manifold Plenum And I Can See That Cpi Is...
1 ANSWER
Asked by antoniomatatorres

I Believe I'm Having A Heat Induced Electrical Failure...

1995 CHEVROLET BLAZER
I Believe I'm Having A Heat Induced Electrical Failure. I've Replaced Numerous Parts While Resorting The Blazer My Wife Bought. Previous...
9 ANSWERS
1 IMAGE
Asked by Mr_Wizard

IM TRYING TO CHANGE A CRANK SENSORE. I PULLED THE...

1995 CHEVROLET SILVERADO
Im Trying To Change A Crank Sensore. I Pulled The Wires Off Trying To Pull It Out. It Wont Just Pull Out. What Should I Try?
1 ANSWER
Asked by Anonymous

Browse other repair topics

Browse by repair topic
SymptomsAir FilterAir Intake Temperature SensorAir Intake TubeBalance ShaftBlockCamshaftComputerCoverCrankshaftCrankshaft PulleyCylinder HeadDipstickDrain PlugEstimateFlexplateFlywheelGround StrapHarmonic BalancerIdentificationIdle Air ControlIntake ManifoldInterchangeKnock SensorMAP SensorMass Air Flow SensorMountOilOil ChangeOil CheckOil CoolerOil Fill CapOil FilterOil Level SensorOil PanOil Pressure SensorOil PumpOxygen SensorPistonRebuildReplace/RemoveSerpentine BeltStarterSuper ChargerThrottle BodyTiming BeltTiming ChainTune-upTurboVacuum Hose DiagramWiring

    Can’t find your issue?

    Ask a new Chevrolet question