Toyota Engine

Browse Toyota Engine questions and answers. Choose a question that matches your symptoms.

9,253 discussions


Oxygen Sensor Heater Control Circuit Low, Code P0031

2007 TOYOTA RAV4
Engine, Vsc, 4 Wheel Lights On. I Checked It Obd Scanner It Says P0031 Oxygen Sensor Heater Control Circuit Low (bank 1 Sensor 1). I...
2 ANSWERS
14 IMAGES
Asked by Hans Duhaylungsod

Shaking At 2,000 RPMs

2007 TOYOTA AVALON
Okay, So I Just Bought This Car And Don't Want To Put Much Into It As It's Just A Get Me By Car. But I Noticed Recently Shaking...
1 ANSWER
Asked by micdet200

Running Hot, Heat Vent Blowing Cold

2007 TOYOTA CAMRY
The Car Runs Hot And Then Will Go Back Down And No Heat Comes Out If I Am At A Light While It Is Down It Goes Back Up. I Was Low On Oil Due...
1 ANSWER
Asked by Darling01

Engine Shut Off After Overheating

2007 TOYOTA YARIS
We Drove Long Distance, Approximately 2.5 Hours. The Water Light/temperature Appeared Upon Us Driving Uphill. We Let The Car To Free Wheel...
9 ANSWERS
3 IMAGES
Asked by Nicole Chelsey Brown

Oil Type

2007 TOYOTA CAMRY
Hello, I Put Ow-30 Into My Car Engine For Oil Change Instead Of 5w-30, Should I Be Worried?
3 ANSWERS
2 IMAGES
Asked by opeyemiarex99

Motor Vibration

2007 TOYOTA COROLLA
I Have Replaced The Motor Mounts And Serpentine Belt And My Car Still Vibrates.
1 ANSWER
Asked by Dwight777

Car Turns On But No Power Of Acceleration After Intake...

2007 TOYOTA COROLLA
I Recently Changed My Intake Manifold Gasket On My Car After A P0171 Code. When I Was Removing My Manifold A Coolant Tube On The Throttle...
3 ANSWERS
1 IMAGE
Asked by Theegarciagarcia

Serpentine Belt Pulley Replacement

2007 TOYOTA SIENNA
I Want To Replace The Pulley On My Belt Tensioner (squeaks) But I Don't Want To Replace The Entire Tensioner Just The Pulley Because I...
7 ANSWERS
Asked by R. Carpenter

Engine Load Definition

2007 TOYOTA COROLLA
This Is Just A Technical Question I Don't Know If You Are Allowed To Answer It. What The Definition Of Engine Load? Thank You
1 ANSWER
Asked by lastmoh

Will Not Start After Replacing The Crankshaft Position...

2007 TOYOTA TUNDRA
I Replaced The Crankshaft Position Sensor Because I Got A Code Saying It Was Bad And Had Trouble Starting A Few Times But After I Replaced...
5 ANSWERS
3 IMAGES
Asked by Mikeh12

Browse other repair topics

Browse by repair topic
SymptomsAir FilterAir Intake Temperature SensorAir Intake TubeBalance ShaftBlockCamshaftComputerCoverCrankshaftCrankshaft PulleyCylinder HeadTickDrain PlugEstimateFlexplateFlywheelGround StrapHarmonic BalancerIdentificationIdle Air ControlIntake ManifoldInterchangeKnockMAP SensorMass Air Flow SensorMountOil LeakOil ChangeOil CheckOil CoolerOil Fill CapOil FilterOil PanOil Pressure SensorOil PumpOxygen SensorPistonRebuildReplace/RemoveSerpentine BeltStarterSuper ChargerThrottle BodyTiming BeltTiming ChainTune-upTurboVacuum Hose DiagramWiring

    Can’t find your issue?

    Ask a new Toyota question