CYLINDER HEAD

My Vehicle Is A Honda Rd1 Cr-v Japan Model Year 2001. I Have Been Told That The Engine Needs To Be Replaced As The Second Gasket That Was...

Please Tell Me The Best Way To Get Out The Head Bolt After I Rounded It Off.

I Have Tty Bolts (the Same Ones From Your 5.3 Video) And On My Final Pass For Bolt #9 And #10, I Accidentally Went To 90 Degrees Instead Of...

I Recently Did A Top-end Overhaul On A Nissan Yd25 Engine, Tested The Vehicle For 190 Km. Then Later Heard A Blowing Sound From The Inlet...

I Am Contemplating Buying An Immaculate, Low Mileage Le Sabre That Has Been Sitting Two Months. Apparently, The Car Overheated And Now Won...

Hello. I Purchased A Nissan Head Unit Online. It Was Scrapped From A Vehicle, So I Don't Know Exactly What Vehicle It Was Taken From...

Do I Remove Head Bolts In Same Pattern To Remove As Installed?

With No Power Until 20 Mph, Did Compression Check To Find. Right Side All 3 At 175 Lbs. (Plugs Stark White). Left Side All At 75 Lbs. (...

I Have The Truck Listed Above 1500. I’m Changing Out Cylinder Heads. The Cylinder Heads I Removed Was 706 I Got A Good Deal On One New...

Ok Having Replaced The Gaskets And Heads, Torqued To Specs In 3 Rounds In Pattern Shown. Problem Being A Slight Water Leak At The Front...