CYLINDER HEAD VALVES Questions
1989 Toyota Tercel Valve Seal Replace
My '89 Tercel 125,000 Mi. Was Running Rough While Idling Only. I Performed A Compression Test And Found #4 Cyl. Low Compression, Burnt...
Asked by riggle
1998 Honda Accord Timing.
I Am Putting A New Cylinder Head On To Replace The Old One That Was Stolen. The Camshaft Is Pretty Easy To Determine Where I Need To Set It...
Asked by ChocolateThunda
Chevy 5.7 Ltre Compresion Lost
Lost Compresion On Chevy 5.7 V-8 On #4 & 6 Cylincers.
Was Told Could Be Valves, Gaskets (head, Valve Cover, Or Exhaust). Any Suggestions...
Asked by raxter
What Could Be The Problem When Two Cylinder Head...
What Could Be The Problem When Two Cylinder Head Valves Are Not Firing Out Of The Eight Valves? This Car Has Been Parked For Ten Months...
Asked by Anonymous
1990 Pontiac 6000
The Car Just Dies. Sometimes It Will Restart Rite Away Sometimes It Doesn't. Idea's?
Fuel Pressure Is 40 Psi, Within Spec, Pressure Stays...
Asked by Whitelight
2000 Dodge Caravan 3.3 Upper Eng Noise Clanking Rear...
Loud Clanking Sound From Rear Head. Rocker Covers Off, No Visible Damage. Rockers Show Very Little Oil And Sludge Is Heavy Inside Both V/...
Asked by jlherrm
1993 Chevy Blazer Heads?
I Got A 1993 Blazer, My Problem Is That When I Try To Start It, It Backfires & Breaks The Starter Bolts! I've Replace The Starter Twice Now...
Asked by scoota_4
Volkswagen Passat
My 2000 Volkswagen Passat Has A Very Rough Idle And Flashing Engine Light. I Got So Much Expensive Work Done On This Car I Can't Afford It...
Asked by Mcswain
2000 Toyota Celica Completely Stumped
Head Job Due To 8 Bent Intake Valves And A Sheared Intake It Cam Dowel. Car Idles High (1500 Rpm) Chatters Loudly In The Valve Train. When...
Asked by jsower
New Intake Valve Covers Touch Intake Wont Bolt On
New Intake Valve Covers Touch Intake Wont Bolt On
Asked by Anonymous
