REPLACE/REMOVE SENSOR CRANKSHAFT Questions
1998 Mercedes Benz C230 Replacing Crankshaft Position...
Engine Mechanical Problem
1998 Mercedes Benz C230 4 Cyl Two Wheel Drive Automatic
Where Is The Crankshaft Position Sensor Loacted. I...
Asked by Hugo
Sensor Replacement
My Car Has An Issue When It Is Cold. After It Warms Up Fully The Issue Disappears. There Is No Check Engine Light That Has Been Tripped But...
Asked by Chris Gangle
Crankshaft Sensor Replacement
My Car Started To Have A Rough Idle And Wouldn’t Let Me Gain Speed. The Rpm's Would Go Down And I Would Slow Down. Checked The Engine...
Asked by Faith98
Replaced The CAM Sensor As Well As The CRANK Sensor...
My Truck Died While I Was Driving. Hooked It Up To The Scanner And It Threw A Cam Sensor Code, Replaced The Cam Sensor As Well As The Crank...
Asked by angelaputt
Possible Crankshaft Sensor Replacement
A Mechanic Came And Looked At It And Said He Thinks This Is My Problem. He Wanted To Check On The Return Policy Of The Sensor Just In Case...
Asked by yourellady
My Buick Had Stalled Occasionally While Driving When...
My Buick Had Stalled Occasionally While Driving When Cold And I Would Pull Over And Restart It. I Did A Full Tune Up And Replaced The Fuel...
Asked by z69ranger
1997 Ford Probe My Car Wont Move
I Replaced Crank Shaft Censor And Now Car Will Not Take Off. Is It The Crank Shaft.
Asked by fordprobea
Car Starts Sputtering While Driving Will Die Takes A...
Car Starts Sputtering While Driving Will Die Takes A Few Minutes To Start Back. Just Replaced A Crank Shaft Sensor But Still Having Same...
Asked by Eufaulagurl
Crank Sensor Relearn Procedure Not Taking
Had To Replace Crank Sensor. Tried Relearn Procedure Will Start, But Will Not Finish.
Asked by Tucker 2012
Help: Frequent Car Choke
I Have A 2000 Mazda Protege (1.8l, 52 K Miles) That Ran Very Well Until Last Month. Two Weeks After I Had A 800-mile Trip, The Engine...
Asked by Fredine
