TCC solenoid

TOYOTA COROLLA
Avatar
ROCK2001WWF
  • MEMBER
  • 10 POSTS
My car stall when stop completely for a couple of seconds, I have changed fuel filter, coolant temp. sensor, and tune up stuffs.
I try to change to TCC solenoid, in my 1993 corolla 1.8 liter engine.
Where is it?
And how do i tell if the tcc solenoid is working?
Apr 24, 2006 at 7:21 PM
Advertisement
Avatar
LOSONE
  • ✓ASE Certified Mechanic
  • 1,616 POSTS
  • ASE Certified Mechanic
The TCC solonoid is the electronic device that causes the torque converter to lock-up and un lock when you are the drive over about 45.

Drive about 50, touch the brake lightly, if it is working the torgue converter will disengage and you will hear and engine rpm increase. After you hear the increase, it will shift back into lock up. The rpm change is about 250.

If the torgue converter will not unlock then it is a major stall condition as it will be a direct connection to the engine without a torgue converter. Good luck
Apr 24, 2006 at 7:33 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.