2000 Chrysler Town and Country sensor

2000 CHRYSLER TOWN AND COUNTRY
214,112 MILES • 3.3L • 6 CYL • 2WD • AUTOMATIC
Avatar
LATINTONY1
  • MEMBER
  • 1 POST
I have a 2000 town and country that overheated do to radiator leak,I replaced the radiator but now my engine light turned on.
Jul 28, 2014 at 9:07 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
CARADIODOC
  • CAR REPAIR CONTRIBUTOR
  • 34,308 POSTS
You left something unplugged or you turned the ignition switch on while it was unplugged. There's going to be a diagnostic fault code in the Engine Computer. Chrysler makes reading them yourself easier than any other manufacturer. Cycle the ignition switch three times from "off" to "run" without cranking the engine, leave it in "run", then watch the code numbers appear in the odometer display. Holler back with those numbers.
Jul 28, 2014 at 9:18 PM
Advertisement