SPONSORED LINKS

Toyota 4-runner 2.4 cooling system.

Tiny
THEZERO
  • MEMBER
  • 1991 TOYOTA 4RUNNER
  • 4WD
  • MANUAL
  • 244,000 MILES
4 runner 1991 2.4 turbo diesel. Having somewhat overhauled cooling system ie thrmo, new water pump and a good flush to ensure no blockage, things not as they should be. Have had to replace gasket on water pump 4 times due to mysterious leakage. On final attempt, as there were no indications of other problems, went all out to fit fail proof over kill gasket. That held until pressure in the system blew out through radiator cap which is fitted with pressure release device, then gasket failed again. Is this head gasket problem? I have no water in the oil and no smoke from exhaust and as far as I can tell no loss in power and as long as I have enough water in the system, no overheating. After a summer under the hood, I'm back where I started and clueless. Any ideas?
SPONSORED LINKS
Sunday, August 14th, 2011 AT 12:08 PM

1 Reply

Tiny
KHLOW2008
  • MECHANIC
  • 41,814 POSTS
If pressure is blowing the pressure out of the cap, most likely you have a bad head gasket. It does not necessarily mean water would get into the oil or vice versa when head gasket fails as the head gasket are of metal type which does not leak badly when they fails.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Sunday, August 14th, 2011 AT 12:59 PM

Please login or register to post a reply.

Related Cylinder Head Gasket Blown Content

Cylinder Head Gasket Blown Test
GUIDE
Cylinder Head Gasket Blown Test
Diagnosing a blown head gasket in an automotive engine requires a systematic approach to ensure accurate results. This guide will walk you through the necessary steps to...
VIEW MORE

Sponsored links