NISSAN ALTIMA

The Pulley Has Been Removed. So, The Question Is When I Purchased The New Idler Pulley The Inside Bearing Is Sealed. And The Hole Is...

Can Anyone Tell Me Where The Third Motor Mount Is Located? I Got The Front Passenger Top Mount And The Front Lower Center Mount. The Engine...

Hello, Can Someone Please Tell Me How To Remove The Top Idler Pulley? It Appears To Be Attached With A Single Bolt/ Fastener. The Problem...

My Old Belt Tensioner Busted Off Somehow While Driving. I Need To Install The New One, But I'm Not Sure How To Install It And If I Need...

The Compressor Clutch Does Not Engage. The A/c Fuse Is Good But There Is No Power To The Control Side Of The A/c Relay. I Suspect It Is The...

The Compressor Is Engaging. I Have Vacuumed The System And Filled It. I Will Include A Photo Of My Current Gauge Reading At Outside...

The Car Had A Bad Engine, So I Got The Engine Swapped. The Car Would Run Fine Before Engine Swap. Now That The Engine Has Been Swapped It...

I Have Removed The Glove Box And I Need To Know How To Remove Floor Duct To Access The Actuator?

I Have Replaced The Water Pump, Radiator, Cooling Fan Assembly, Fan Sensor, Thermostat And Radiator Cap. The Car Does Not Overheat But...

Ever Since I’ve Got This Car Listed Above, I’ve Noticed That Sometimes It Would Start Up Really Bad Especially During Cold Starts. It...