NISSAN 300ZX TRANSMISSION CLUTCH

Found 9 results

Select a filter to limit the results

Symptoms Cable Master Cylinder Pedal Pressure Plate Slave Cylinder

I Took My Car To A Certified Mechanic, He Replaced...

I Took My Car To A Certified Mechanic, He Replaced The Clutch Plate, Water Pump System, Etc. Totaling $800, Now Every Since Then, My Car...

Asked by MzAGel ·

1 ANSWER

1996

How to Check Your Clutch Operation?

VIDEO

How to Check Your Clutch Operation?

Instructional repair video

Clutch Replacement

Clutch Replacement

Before you replace your clutch its a good idea to see how the clutch works and the symptoms of a bad clutch. A clutch will have problems and can stop working all...

1990 Nissan 300ZX Clutch Problem?

I Was Driving (normal, Not Hotrodding) And I Went To Shift To 3rd And It Would Not Go Into Gear. It Felt Like When You Try To Go Into Gear...

Asked by prduke ·

3 ANSWERS

1990

1991 Nissan 300ZX No Pressure In Clutch

I Have A 91 300zx And Just Replaced The Clutch Master And Slave Cylinder And Have Been Bleeding The Lines For 2hr. Ran About A Pint Of Fluid...

Asked by mcim81 ·

2 ANSWERS

1991

1990 Nissan 300ZX Clutch

I Am Having A Problem With My Clutch, There Was A Loss Of Ressure In My Clutch Pedal. I Am Trying To Bleed The Clutch And Cannot See A...

Asked by sonnybaby05 ·

1 ANSWER

1990

Clutch and Throwout Bearing Front Wheel Drive

VIDEO

Clutch and Throwout Bearing Front Wheel Drive

Instructional repair video

Transmission

So While Driving The 300 Zx When Pressing In The Clutch There Is A Grinding Noise, Pulled Apart The Transmission And Took Out Throw Out...

Asked by nezywick ·

1 ANSWER

1985

Clutch

I Have A Nissan 300zx Its A 1986 And My Clutch Pedal Wont Come All The Way Out And Its Really Hard To Shift When It Does That

Asked by diesel2100 ·

1 ANSWER

1986

Clutch - How it works

Clutch - How it works

The clutch assembly is mounted to the flywheel, which is located between the engine and transmission. The clutch disc is designed to disengage, and then re-engage power...

1984 Nissan 300ZX Clutch

I Have An Issue With My Clutch. It Was Replaced Less Than 5 Months Ago. Has Been In And Out Of The Shop For Problem. Never Have I Had A...

Asked by jewboi85 ·

1 ANSWER

1984

Clutch, Master Cylinder

I Have A 95 Nissan 300zx With 165,000 Miles. I Have Been Experiencing A Lag/loss Of Power Between Each Of My Shifts At Low Rpm Almost Like...

Asked by jazzed2b ·

1 ANSWER

Clutch Pressure Plate

The Car Was Flooded. I Have Replaced The Slave Cylinder And Cleaned All Tubes. I'm Thinking That The Pressure Plate Is Rusted Stuck....

Asked by joepotter531 ·

1 ANSWER

1984

Ask a new Nissan 300ZX question

Sponsored links

Ask a Car Question. It's Free!

SPONSORED LINKS

Online car repair manuals

Online car repair manuals

© 1999 - 2024 2CarPros, Inc.