Mazda


Are There Torque Specs For The Front Outer Tie Rods...

2000 MAZDA PROTEGE
I Usually See Recommendations Of Between 22-30 Ft-lbs. For The Outer Tie Rods But Haven't Seen Anything Specific For The Sway Bar End...
1 ANSWER
5 IMAGES
Asked by noface

Can I Use A Universal Catalytic Converter Replacement

2017 MAZDA 3
I Hollowed My Catalytic Converter (for Pops Tune) And I Didn’t Like The Sound, It Had A Metallic Sound Inside The Car When I But Gas. ...
3 ANSWERS
2 IMAGES
Asked by Fadu

No Start After Engine Swap

2009 MAZDA 3
I Swapped Out A 2.0 On The Car Listed Above With Another 2.0. It Turns Over But Very Sluggish. It Turns About Two Revolutions Then It Stops...
3 ANSWERS
Asked by Benefitsal

Spark At Coil But Not At Distributor Cap

2000 MAZDA MILLENIA
I Own The Vehicle Listed Above V6. I Saw That You Had The Same Problem As I Did, And I Received Spark On The Coil But Not At The Cap, Even...
1 ANSWER
1 IMAGE
Asked by Mauricio Solorzano

Running Lights Intermittently Not Working

2005 MAZDA 3
Running Lights Work Intermittently. There Are Times When I Cannot Get Them To Work.
1 ANSWER
2 IMAGES
Asked by sf1522@yahoo.com

Engine Shuts Off When Transmission Is Shifted Into...

2003 MAZDA MPV
I'm Fixing My Neighbor's Car. I Put A New Iac In, It's Not The Problem. When In Park It Starts Up Kind Of Have To Flutter The...
1 ANSWER
Asked by Tbagmpv

Code U0101

2010 MAZDA 3
Have A Code U0101 Which Points To The Tcm Being Bad. I’ve Been Told On This Model With A 2.0 The Ecu Does The Job Of A Tcm. Does My Car...
1 ANSWER
6 IMAGES
Asked by Jcole302

Power Steering Not Working, Code C1277

2007 MAZDA 3
Finally Got Codes On The Car. There Is A C1277 Code, Bad Steering Angle Sensor. It Is A Little Unclear Whether Replacing The Sensor Would...
3 ANSWERS
4 IMAGES
Asked by fourkids

Misfire Or Bad Performance

2018 MAZDA 3
Hello Car People, I Had My Spark Plugs Changed 4 Months Ago And Prior To That 6 Months Ago. I Also Had Three Ignition Coils Changed...
32 ANSWERS
1 VIDEO
13 IMAGES
Asked by Kayva

Probing Injectors To PCM Harness

1994 MAZDA PROTEGE
1. When I Check The Injector Harness, With The Key To On, I Get 12 Volts On Both Pins. Is That Supposed To Be? Much Of The Internet Says...
5 ANSWERS
5 IMAGES
Asked by Henry Johnson2
Ask a new Mazda question