Jeep Wangler YJ Repair Questions and Answers
BrakesClimate ControlDrivetrainElectricalEmissionEngineEngine CoolingExhaustExterior LightFuel SystemGeneralIgnitionInteriorSafetySteeringSuspensionTiresWarning Lights
Ignition Key
Looking For Video Or Any Knowledge On How To Remove And Replace Ignition Switch That Goes To The Actuator Rod. Anything Will Be Appreciated.
Asked by Jerry Thurston
Bleeding Brakes
So I Recently Bought And Installed A New Master Cylinder, After Bench Bleeding The Master Cylinder And Hooking Everything Up The Brake Pedal...
Asked by rileyduplain
Quit Starting
Okay, So It Was Starting Fine. Then Now Nothing. I Have Replaced Crank Sensor. I Have Constant Fire On One Side Of The Coil And When I Turn...
Asked by Jaybos10
Vacuum Lines
The Vehicle Was Running Good Parked It For About Six Months Tried To Start It Up Bust Up Bad, Got To Constantly Give Gas To Keep Running....
Asked by Kevin Smith4
Engine Cranks, But Will Not Start
My Vehicle Acted Funny While Driving At Highway Speeds. Choked And Sputtered When I Would Hit The Throttle Almost Like It Was Out Of Gas...
Asked by Luke Brigham
Will Only Start If I Hold Down Gas Pedal
I Tried Starting The Vehicle This Morning And It Would Crank But Would Not Start. The Only Way I Could Get It To Start Was To Hold Down Gas...
Asked by kwc2005
Clutch Replacement
I Replaced The Clutch Master And Slave (throw Out Bearing), New Pressure Plate And Everything, The Old Stuff Was Shot. I Put The...
Asked by Genzod
Transmission Swap
Can I Replace A Five Speed Transmission Yj 1997 For A Wrangler 1988?
Asked by Pascal Cyr
Crank Position Sensor (CPS)
I Installed A New Cps Two Weeks Ago And It Failed Yesterday. I Put One On This Morning And It Worked Initially But Quit Working After A...
Asked by John S Crowe
Ask a new Jeep Wangler YJ question
