GMC Sonoma Repair Questions and Answers
BodyBrakesClimate ControlDrivetrainElectricalEmissionEngineEngine CoolingExhaustExterior LightFuel SystemGeneralIgnitionInteriorSafetySecuritySteeringSuspensionTiresTrouble CodesWarning Lights
Fuel Filter Line
When I Changed My Fuel Filter Gas Continued To Pour Out Of The Rear Fuel Filter Line. It Was Not A Trickle. Is This Occurrence Normal?
Asked by Vgaskins
No Spark From Coil
I Am At A Loss Here, I Shut The Truck Off One Day And Came Back Out Approximately 10 Minutes Later And It Would Not Start. Engine Turns Over...
Asked by badots28
Headlights Adjustment
Headlights Are Out Of Whack And Won’t Adjust Back To Normal. Tried Both Up And Down Screws And Low Beams Are Acceptable But The High Look...
Asked by Doob
Will Not Stay Running?
I Have The Truck Listed Above That Has Complete Engine Rebuild, New Map, New Distributor, New Ignition Switch, All New Sensors, New Fuel...
Asked by ortegaeddie
Can You Advise Me As To What Torque Wrench I Need To...
Getting Ready To Replace The Valve Body On My 4l60e Transmission. I Usually Do Not Use A Torque Wrench, Just Snug It Up, And A Little More...
Asked by Bonairk
Does My Truck Have Keyless Entry?
I Am Trying To Find Out If My Truck Listed Above Ext Cab, Sls Model Has A Keyless Entry. It’s A Basic Trim Package. Thank You.
Asked by Doob
Brake Pedal Is Too High After Replacing The Brake...
I Replaced The Brake Booster And Brakes Are Working Well. But My Pedal Is Way Too High.
Asked by Doob
My Truck Is Leaning To One Side
My Tuck Has A Lean. It’s About 1.5 Inches Higher On Pass Side. So I’m Wondering If I Could Adjust Torsion Bar To Get Me 1.5 In To Level...
Asked by Doob
Vacuum Diagram
I Have Had To Rebuild The Engine. While Rebuilding The Engine, I Noticed That All The Vacuum Lines Where Falling Apart. The Engine Starts...
Asked by Awilkins78
Ask a new GMC Sonoma question
