GMC Engine

Browse GMC Engine questions and answers. Choose a question that matches your symptoms.

4,524 discussions


Codes P0521, P0340, P0341, And P0016, After Replacing...

2006 GMC ENVOY
I Replaced The Rear Main Seal On My Vehicle Listed Above Xl Denali And Now I Have Codes, P0521, P0340, P0341, And P0016.
1 ANSWER
Asked by Saeli Saeli

Can I Get A Vacuum Lines Diagram?

2006 GMC ENVOY
Vacuum System Diagram Needed.
10 ANSWERS
2 IMAGES
Asked by MrDeeds321

Put A New Battery And Alternator In But It Is Not...

2006 GMC ENVOY
Put A New Battery And Alternator In But It Is Not Turning Over. It Sounds Like It Wants To Start But It Doesn't.
3 ANSWERS
Asked by MamaWolfe68

Losing Oil?

2006 GMC SIERRA
I Recently Did An Oil Change. And Yesterday I Got A Check Oil Level Came On. When I Checked It Was A Quarter Low. There's No Leaking...
1 ANSWER
Asked by Leonard Ortega

The Fan Revs High Occasionally When The Vehicle Runs...

2006 GMC ENVOY
The Fan On The Motor Revs High And Makes A Pound Revving Sound Sometimes When The Vehicle Runs For A While, But It Seems To Only Do It When...
3 ANSWERS
4 IMAGES
Asked by Shannon454545

Car Stalls Then Crank No Start?

2006 GMC ENVOY
I Am Having A Few Problems With The Vehicle Listed Above, But The Main Ones Are Stalling And Cranking But Not Starting. They Are Both...
1 ANSWER
15 IMAGES
Asked by toomanycarproblems

Engine Will Not Stay Running

2006 GMC YUKON
Seems Like It’s Starving For Gas, Engine Shuts Off After Idling For About 10 Minutes. Could It Be A Possible Fuel Filter Issue?
1 ANSWER
Asked by Dianna Jackson

No Start After Manifold Gaskets Replaced

2006 GMC YUKON
Truck Had Codes P0171 And P0174 And Wouldn’t Pick Up Acceleration. After Looking Up The Codes And Common Fixes To The Problem It Led Me To...
1 ANSWER
Asked by MLBx

Cylinder Head Bolts Torque Spec Needed

2006 GMC ENVOY
What Is The Cylinder Head Bolt Torque On The Vehicle Listed Above Xl Denali?
1 ANSWER
2 IMAGES
Asked by Tiara Gary Clifton

Transfer Case Control Module

2006 GMC SIERRA
When Checking For 5vlt At Signal Wire (lt Grn/blck + Blk/wht)at Female End Of Harness At Encoder Motor. I Don't Get A Reading Until I Put...
8 ANSWERS
6 IMAGES
Asked by BLCKLBRTRVR

Browse other repair topics

Browse by repair topic
SymptomsAir FilterAir Intake Temperature SensorAir Intake TubeBlockCamshaftComputerCoverCrankshaftCrankshaft PulleyCylinder HeadTickDrain PlugFlexplateFlywheelGround StrapHarmonic BalancerIdentificationIdle Air ControlIntake ManifoldInterchangeKnockMAP SensorMass Air Flow SensorMountOil LeakOil ChangeOil CheckOil CoolerOil Fill CapOil FilterOil PanOil Pressure SensorOil PumpOxygen SensorPistonRebuildReplace/RemoveSerpentine BeltStarterSuper ChargerThrottle BodyTiming BeltTiming ChainTune-upTurboVacuum Hose DiagramWiring

    Can’t find your issue?

    Ask a new GMC question