Ford Ranger Computer Read Codes
Browse Ford Ranger Computer Read Codes questions and answers. Choose a question that matches your symptoms.
7 discussions
2001 Ford Ranger Reading 2 Different Emission Codes
Check Engine Light Comes On. The Code Was Po175 -- Too Rich. Replaced One Of Two Oxygen Sensors, Downstream From Cat Converter. Reset, Now...
Asked by mackisus
1999 Ford Ranger Motor Has A Miss
The Motor Has A Miss In It Like A Dead Cylinder. All Wire Check Out. Run A Computer Test. It Says The Egr Vavle Has Insufficent Flow. Could...
Asked by jayrun1
Could My PCM Be Fried
I Was Driving On The Interstate And Out Of Nowhere The Ceramic Piece Of Spark Plug Blew Out. Unplugged One Coil Pack And Melted Some Of The...
Asked by Catpek5
1996 Ford Ranger 1996 Ranger Overdrive
Hello, I Recently Purchased A 1996 Ranger 4cyl Automatic 107k Miles. It Was A Fleet Vehicle Here On Post And Never Left The Post. Top Speed...
Asked by 1996rangerron
1995 Ford Ranger Connection For Code Scan
I Have Read That The Connection For The Code Scanner Is Under The Dash For My 1995 Ford Ranger. I Cannot Find It. The Repair Manuals Are...
Asked by jjjrstevens
I Have Been Doing Some Reading And Im Looking For An...
I Have Scan Tools But Not Even Sure If It Is Possible For Me To Even Connect It Some How
Asked by Jeff Scheirer
OBD 1 Get Codes
I Have Followed The Procedure To Do A Test To Get Codes With A Test Light And My Light Stays On Constantly Does Not Flash. I Have Tried...
Asked by Winfred
Browse other repair topics
Clear CodesDiagnostic Connector ALDLEstimateLimp Mode - Reduced PowerLocationMonitor Not ResettingNo CommunicationProgramRead CodesReplace/Remove
Can’t find your issue?
Ask a new Ford Ranger question
