Ford Mustang Drivetrain
Browse Ford Mustang Drivetrain questions and answers. Choose a question that matches your symptoms.
344 discussions
Stuck Into 2 Gears At Once
I Have A 1966 Mustang That I Have Somehow Managed To Get Stuck Into 2 Gears At Once. I Have No Idea What Caused This Issue Or How To Resolve...
Asked by vgarbett
Clutch Pedal Has Down Pressure But Won't Return
Fixmr Asked If Clutch Was Cable Or Hydraulic - Neither
Asked by Edward Quinlan
Why Does Clutch Pedal Have Down Pressure But Won't...
Just Installed New 3-speed Transmission, Pressure Place And Clutch
Asked by Edward Quinlan
1966 Ford Mustang Adjust Clutch
Transmission Problem
1966 Ford Mustang 6 Cyl Two Wheel Drive Manual ? Miles
I Just Purchased An Old Mustang. It Has A New Clutch That...
Asked by nodakborn56
1966 Ford Mustang Neutral Safety Switch
Electrical Problem
1966 Ford Mustang V8 Two Wheel Drive Automatic 0
Power At Ignition. No Power At Solenoid. Power At Leads To Neutral...
Asked by bleverman
1966 Ford Mustang Fluid Leak
I Have The Above Convertable Mustang And It Is Leaking Fluid Which I Believe To Be Transmission Fluid. What Might Be Causing This In An Old...
Asked by imrcr
1966 Ford Mustang Rear Axle
Drive Train Axles Bearings Problem
1966 Ford Mustang 6 Cyl Two Wheel Drive Manual
How Do Disassemble A Ford 9inch Rear Axle
Asked by onlydrinkkoolaid
Ford Mustang 1966 Restoration Re: Starter Ring Gear
On This 66 Car. The Original Automatic 289 Engine Was Replaced With A High Performance 289. The Starter Ring Gear Has 160 Teeth. The...
Asked by woodly
Pilot Bearing Size
I'm Doing A C-4 To T-5 Transmission Swap In My Car. The Pilot Bearing That I Received In The Clutch Kit Is 44 Thousandths Smaller Than...
Asked by jarmagn1
My 1965 Mustang Has A 3 Speed Manual Transmission (...
My 1965 Mustang Has A 3 Speed Manual Transmission (unsynchronized 1st Gear). My Question Is About A Clanking Noise Emanating From The Trans...
Asked by vapor
Browse other repair topics
Can’t find your issue?
Ask a new Ford Mustang question
