FORD COMPUTER

My Vin Starts With Letter P. Do I Need To Reprogram The Ecu/pcm After Replacement? My Problem With This Car Was: My Radiator Fan (low Speed...

Okay, So, I Get These 3 Codes And They Will Not Clear Or Go Away Even When I Reset The Pcm. So Here Is A List Of Things I’ve Changed. It...

I Need A Pen Out Of The Pcm For The Vehicle Listed Above With A 2.0 Zetec Engine. I Have A Crank Signal, But I Have No Rpm Signal And I Am...

After I Ground The Valves, I Could Start The Car. I Attempt To Carry Out Scanning But Failed To Communicate. Pcm Is Not Communicating With...

The Car Listed Above Is A Mk7, It Has Started Going Into Limp Mode After Displaying 'engine Service Now' And 'hill Start Assist...

I Have The Car Listed Above Convertible, The Obd Port Is Getting Power, However It Will Not Link, Or Read Scanner. Any Ideas, Any Help...

I Had A Cylinder Four Misfire And Was Told I Needed A Motor. They Put The Motor In, But The Car Was Still Acting Up, So They Put A...

I Have To Find Some Possible Intermittent In Wire Going To The Pcm.

I Was Driving Home One Day And Just Started Missing And Went Into Limp Mode Cylinder 3 Was The Code. I Have Changed All The Plugs And Coils...

Hi, I Have A Problem As Far As When I Go To Inspection All My O2 And Catalyst Monitors Will Not Complete A Drive Cycle. I Put A New Battery...