Dodge Raider
Ignition Coil Ballast And Distributor?
I Need To Know Whether Two Wires Go From The Distributor To The Ignition Coil And Ballast How The Wiring Run. Thank You
Asked by Mypitts
Swapped Engines And Want To Use Factory Tachometer
I Have The Truck Listed Above. I Have Done An 1995 Chevrolet 4.3 Engine Swap With Hei Distributor. I Want To Use The Factory Tachometer...
Asked by Jammer1 million
Alternator Swap
Are There Any Other Alternators That Are Compatible With My Vehicle?
Asked by debralbrown67
4wd System Not Working
My 4wd Doesn't Work. I Wanted To Know If The 4wd Is Activated By Vacuum Lines, Electronically, Or Just By Putting Lever In 4low Or 4hi?...
Asked by Mr.Knothead
Coolant Mixing With Oil
Hello, It Was Ran Overheated For Fifteen Minutes Or So And I Cracked The Head.
I Have Since Replaced The Head With A Brand New One....
Asked by gaffneyk
No Power To Ignition Starting Or Dash (intermittent)
I Am Working On A Buddies Raider And I Am Loosing All Power To The Ignition Switch. You Can Drive It Down The Road And It Will Randomly...
Asked by hedalope
1987 Dodge Raider 4 Wheel Drive System
My 1987 Dodge Raider Sab 4x4 Has Been Extremely Taken Care Of Down To The Wiring Of The Vehicle. I Have Literally Replaced Just About Every...
Asked by 19882fast4u
Best Strategy To Allow The Re-done Engine To Set.
Good Day To You All.
What Is The Best Strategy For Allowing The New Engine To Set?
I Am About To Get My Dodge Raider Back On The...
Asked by Artemio
1988 Dodge Raider Throwout Bearing
I Recently Had The Transmission Rebuilt And I'm Having A Problem Reinstalling The Throwout Bearing Assembly. The Transmission Shop Removed...
Asked by Khermann
I Am Looking At A Used Engine. 2.6 Liter Dodge...
I Am Looking At A Used Engine. 2.6 Liter Dodge Mitsubishi It Has A 170 - 180 Compression Is That Good Or Bad ?
Asked by Anonymous
Ask a new Dodge Raider question
