1987 DODGE RAIDER
Avatar
ANONYMOUS
  • MEMBER
  • 1 POST
I am looking at a used engine. 2.6 liter dodge mitsubishi It has a 170 - 180 compression is that good or bad ?
Nov 8, 2012 at 2:18 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
HMAC300
  • CAR REPAIR CONTRIBUTOR
  • 48,601 POSTS
that's great compression
Nov 8, 2012 at 2:19 PM
Advertisement
Avatar
AUSTINBOHANNON
  • MEMBER
  • 1 POST

Yes that can be a good compression for Dodge Mitsubishi. But tell me where you are looking for this used engine. If you haven’t bought it yet, then I can suggest you one good place called http://www.buyusedengine.com/used_engine.php?make=Dodge where you can get even better compression ratio in used engine for this car. Compression ratio should be higher as it is very advantageous that permits an engine to extract high mechanical energy and allow the same ignition heat to be attained with less fuel.
Jul 16, 2014 at 5:51 AM