Chrysler 300 Engine
Browse Chrysler 300 Engine questions and answers. Choose a question that matches your symptoms.
362 discussions
Code P2314, Rough Idle?
So I'm Being Honest I Recently Changed The Timing Belt Because It Snapped When I Was Driving And It Caused A Crank No Start I'm...
Asked by gabetofye222
The Car Idles Rough, And It Feels Like It Wants To Cut...
I Replaced The Spark Plugs, The Fuel Pump, Fuel Sending Unit, The Water Pump, The Serpentine Belt And Serpentine Tensioner. It Also Has A...
Asked by gabetofye222
Code P0340, Crank No Start?
So, I Replaced My Water Pump, My Fuel Pump And Fuel Sending Unit. I Replaced My Camshaft Position Sensor. I Replaced My Ignition Switch And...
Asked by gabetofye222
In The Morning It Starts Fine, But After A Few Minutes...
In The Morning The Engine Starts Fine But After A Few Minutes' Chokes Down. After It Stalls It Starts Right Back Up And Runs For Another...
Asked by CURTIS C MAJETTE
While Driving Suddenly Lost Power And The Engine...
I Was Driving To Work When All Of A Sudden It Lost Power And The Engine Started Making A Knocking/loud Ticking Noise On The Left Bank Of The...
Asked by Boostislyfe
Intermittent Hard Start, Stalling And Crank No Start...
I Was Called To Another Garage To Fix The Car Listed Above 300c. The Problems They Noticed With The Car Was Hard Or No Start, No Throttle...
Asked by David Davo Essien
Heater Circuit Low For All O2 Sensors?
Recently Purchased This Car Broke Down As A Project To Fix Up Myself, The Only Codes It’s Showing Is The Heater Circuit Low For All 4 O2...
Asked by Noah.b.111
Pin Code, Intermittently Not Starting Horn Blowing?
I Have A Lunch 431v Can’t Find Out Can't Find Out How To Get The Pin Code Can’t Find Out How To Get The Pin Code.
Asked by william927
After Completing An Engine Swap, Low Idle And RPMs...
The Car Listed Above Is A 300c With A 5.7l Hemi. Swapped Engine, Everything Is Back In, Car Running. Experiencing Low Idle And Rpms Breakup...
Asked by colline1121
Car Keeps Stalling
The Car Ran Fine But The Check Engine Light Was On, Had Codes Checked And An O2 Sensor And Oil Pressure Sensor. Reminder That The Great Ran...
Asked by Jay32
Browse other repair topics
SymptomsAir FilterBlockCamshaftComputerCrankshaftCylinder HeadHarmonic BalancerIntake ManifoldInterchangeKnockOil LeakOil ChangeOil CoolerOil FilterOil PanOil Pressure SensorOil PumpOxygen SensorPistonRebuildReplace/RemoveSerpentine BeltStarterThrottle BodyTiming BeltTiming ChainTune-up
Can’t find your issue?
Ask a new Chrysler 300 question
