Chevrolet S-10 Transmission Clutch Throw Out Bearing

Browse Chevrolet S-10 Transmission Clutch Throw Out Bearing questions and answers. Choose a question that matches your symptoms.

6 discussions

1998 Chevy S-10 Clutch

1998 CHEVROLET S-10

The Clutch, Pressure Plate, Pilot Bushing Throw Out Bearing And Slave Cylinder Was Just Replaced. Air Has Been Bled. At Times The Clutch...

2 ANSWERS

Asked by gtownkaylee

1995 CHEVROLET S-10

Replace Clutch Pressure Plate And Throw Out Bearing For A 1995 S10, Will Not Go Into Gear, Just Grinds. Could It Be Low Hydrolic Fluid Or...

5 ANSWERS

1 IMAGE

Asked by Denise Benson

1995 CHEVROLET S-10

Transmission Problem 1995 Chevy S-10 6 Cyl Four Wheel Drive Manual I Just Purchased A 95 S10 The Clutch Engages At About One To Two...

1 ANSWER

Asked by halley22

1993 CHEVROLET S-10

Transmission Problem 1993 Chevy S-10 6 Cyl Manual Does Slave Sylinder Return In Cylinder By Itself Or Is There Supposed To Be Return...

1 ANSWER

Asked by NHGumpy

1991 CHEVROLET S-10

Belt Squeals Pretty Bad, Tried Using Belt Dressing Which Helps For A Bit, But It Always Comes Back. Seems To Go Away When I Press The Clutch...

1 ANSWER

Asked by indymike

1985 CHEVROLET S-10

I Have A Chevy S 10 1985 Long Bed Fleetside 2.8 V6 Manual W/ 230,000 Miles. I Recently Replaced My Carrier Bearing Due To The Rubbing Noise...

1 ANSWER

Asked by starven_marvin664

Browse by repair topic

Can’t find your issue?