S10 clutch

1995 CHEVROLET S-10
4 CYL • 2WD • MANUAL
Avatar
DENISE BENSON
  • MEMBER
  • 3 POSTS
replace clutch pressure plate and throw out bearing for a 1995 s10, will not go into gear, just grinds. Could it be low hydrolic fluid or air in hydrolic?
Feb 11, 2011 at 7:27 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
Was system bleed?
Feb 11, 2011 at 7:55 PM
Advertisement
Avatar
DENISE BENSON
  • MEMBER
  • 3 POSTS
yes
Feb 11, 2011 at 9:12 PM
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
Place a tube over bleedr valve other end in container of fluid. open bleeder pump pedaltill all air is out
Feb 11, 2011 at 9:36 PM
Avatar
DENISE BENSON
  • MEMBER
  • 3 POSTS
how to remove slave cylinder?
Feb 12, 2011 at 4:56 PM
Avatar
DOCFIXIT
  • CAR REPAIR CONTRIBUTOR
  • 18,828 POSTS
Unbolt off bell housing unit it not servicable master and slave sold as unit
Image (Click to enlarge)
Attached Media
Feb 13, 2011 at 7:44 PM