BMW Engine

Browse BMW Engine questions and answers. Choose a question that matches your symptoms.

2,758 discussions


Misfire And Clutch

2004 BMW 525I
Clean Car Listed Above With The M54 Engine. Misfires On Cylinder One. Thinking It Could Be The Coil Since They Are Notorious For It....
43 ANSWERS
20 IMAGES
Asked by Naser Naser

Need Pin Location For Air Intake Meter

2004 BMW 325
5 Pin Mass Airflow. Out Pin An Return So I Can Connect Chip Correct. 325 Ci.
3 ANSWERS
4 IMAGES
Asked by Skmoose

Limp Mode?

2004 BMW 325
325 Chi Convertible. If I Step On The Gas Hard The Car Starts To Cut Off For Awhile After Half Hour Start Working Again. Thank You
1 ANSWER
Asked by Joser213

Cylinder Flooding

2004 BMW M3
Sorry But This Will Be A Long Post As I Will Be Putting As Much Detail As I Can In Here. The Problem Started When I Was Warming Up The...
20 ANSWERS
Asked by erickrayos

Misfire On Cylinder Four, Five And Six

2004 BMW M3
During Cold Start It Will Run Okay With Some Dip Here And There On The Rpm But Once It Is Warmed Up Misfires Happens. Replaced The Coils...
5 ANSWERS
Asked by erickrayos

DSC PROBLEM

2004 BMW X3
My Car Has Been Parked For Almost 3 Years,i Started The Engine Unfortunately Water And Transmission Oil Mixed,i Changed The Cool Then No...
1 ANSWER
Asked by MMathopo

Car Shuts Off And Multiple Electrical Issues

2004 BMW X5
Car Shuts Off Whenever Left With The Batter Switch Turned On. Just Last Week The Navigation System Started Messing Up (not Able To Use, Just...
1 ANSWER
Asked by Mariah Renee Barber

Camshaft Position Sensors And Where Are They Located

2004 BMW X5
How Many Camshaft Position Sensors Does It Have And Where Are They Located?
1 ANSWER
6 IMAGES
Asked by Erika Ojeda Aguirre

Engine Starts But Stalls Out When Given Gas

2004 BMW X5
I Got My Engine To Start By Using Some Starter Fluid. It Seams To Run Okay But When It Warms Up And Give It Gas It Stalls Out And Then Stops...
3 ANSWERS
Asked by davidcnoe

Cannot Get My Car To Start After Rebuilding Engine

2004 BMW X5
I Rebuilt The Engine And After I Completed The Rebuild The Engine Started Up And Ran. There Was No Noise Coming From The Engine. I Took It...
1 ANSWER
Asked by davidcnoe

Browse other repair topics

Browse by repair topic
SymptomsAir FilterAir Intake Temperature SensorAir Intake TubeBalance ShaftBlockCamshaftComputerCoverCrankshaftCrankshaft PulleyCylinder HeadTickEstimateFlywheelGround StrapHarmonic BalancerIdle Air ControlIntake ManifoldInterchangeKnockMAP SensorMass Air Flow SensorMountOil LeakOil ChangeOil CheckOil CoolerOil Fill CapOil FilterOil Level SensorOil PanOil Pressure SensorOil PumpOxygen SensorPistonRebuildReplace/RemoveSerpentine BeltStarterSuper ChargerThrottle BodyTiming BeltTiming ChainTune-upTurboVacuum Hose DiagramWiring

    Can’t find your issue?

    Ask a new BMW question