TIMING Questions
Hard Time Moving Forward
Try To Take Off It Physically Cannot. It Is Like It Is Having A Hard Time. When I Put In Park It Revs Up To Four Rpm Then Holds For Like Two...
Asked by Paula Wiser
Distributor Alignment
1989 Chevy Chevelle V8
I Have Set My Engine On 8 Degrees Before Top Dead Center With Number One On The Right Stroke And Have My...
Asked by geraldbasford
1988 Chevy Truck Ignition Timing?
I Installed A New 5.7l 350 Engine In My Truck. I Didn't Have A Timing Light Handy When I Went To Set The Timing. I Used The Same Distributor...
Asked by spuradik
Setting The Timing Issues
After I Set The Timing On The 3 Chains, I Can't Rotate It Enough Times For It To Come Back So All The Marks Are Aligned Again.
Is This...
Asked by wbowie2620
Engine Ignition Timing
Will An Engine Start Ok If The Base Timing Is Set At Tdc (0 Degrees)?
I Am Modeling A Standard, Classical, Distibutor Ignition System...
Asked by dnivens
2004 Chevrolet Aveo Timing Replacement
I Replaced The Timing Kit At About 58,000, It Went Our Before The Recommended Maintenance Schedule Is At 60,000. The Question That I Have Is...
Asked by alaspian
Civic Ignition Timing Is Backwards
This Is A 1995 Civic Vx, 1.5 Liter Vtec-e, 5-speed Manual, 174,000 Miles. Long, Long Story Coming Up, So Please Bear With Me.
For Over A...
Asked by oh95vx
Could Improper Timing By Mechanic Have Destroyed My...
My Husband Took Our Van In To A Local Shop To Have All The Gaskets Replaced And To Have The Van Inspected For Any Other Issues (had To...
Asked by frickinducky
Possible Timing Problem
I Have A 04 Dodge Ram 3.7, And I Just Replaced The Right Cylinder Head Because The #2 Rocker Tower Was Broken, Prior To Removing The Timing...
Asked by Mikes mobile mechanic service
1993 Plymouth Acclaim Timing Set-up
Had Engine (2.5 Sohc) Apart Down To Pistons Out, But Not The Auxillery Shaft Nor The Balancer Shafts.
On Reassembly,i Get The Crank And...
Asked by Cliff Descloux