CYLINDER HEAD

I Received New Head Bolts, But They Have Grease On Them. Are They Okay To Install In My Cylinder Heads And Torque Them? Or Do I Need To Hit...

And My Chilton Repair Manual It Says To Do It Fifteen Pounds And The Ninety Degrees Of An Another Additional Ninety Degrees Is This Correct...

Valve Cover Bolt Torque Specs Needed.

I Just Replaced The Head Gaskets On My Vehicle And After Getting It All Back Together It Will Not Start. It Cranks Fine But It Does Not...

I Had To Change The Valve Cover Gasket On The Drivers Side. To Do That You Have To Take Off The Upper Intake Plenum. I Replaced That Gasket...

How Can You Set 22ft Lbs On A 1/2 In Drive Torque Wrench With The Lowest Setting Is 25ft Lbs? Or 250 In Lbs Maximum On A 3/8 Drive Torque...

Hi There, My Truck Listed Above 16v Td King Cab. Once Overheat When I Checked The Radiator Was Almost Empty I Topped It Up. After That I...

I Need Torque Specs For Cylinder Head Bolts For 1tr-fe Engine.2.0 Litre Vvti Hilux, 2005 Model. The Bolts Shank Is 10 Mm Measured With...

I Have Two Questions #1 I Did Not Do A Compression Check But I Suspect A Blown Head Gasket, Car Overheated Several Times And There Is Oil...

What Is The Torque Specs For Replacing Head Gaskets? Torque Specs On Heads Valve Covers, The Whole Nine Yards.