CYLINDER HEAD Questions
1996 Chevrolet Silverado Motor Combination
Is It Possible To Use A Lower End From A 5.7 94 Silverado With Vortec Heads Off Of A 96 5.7 Silverado
Asked by Rickyd747
Engine Repair
I Need To Know The Engine Torque Specifications On A 99 Grandam 3400 I Just Got New Heads Put On And I Need The Torque For Them
Asked by chelleoffour
Speedometer Started Going Crazy It Dropped Down 20mph...
Today I Was On The Freeway Heading To Work When All The Sudden My Speedometer Started Going Crazy It Dropped Down 20mph Then Jumped To...
Asked by lilhayes
1994 GMC C3500 Repair
Engine Mechanical Problem
1994 Gmc C3500 V8 Two Wheel Drive Automatic
Is There Anything Specific To Watch Out For When Taking The...
Asked by fuz1zy
I Lost The Position The Camsaft And The Sprockets On...
I Lost The Position The Camsaft And The Sprockets On Both Heads Because Its Have Two Positions
Asked by Anonymous
I Have Lost A Part During Rebuild And Don’t Know...
3vwd07aj5em276645
2014 Vw Jetta. We Send The Head To Machine Shop And Didn’t Get This Piece When It Came Back. I’m Pretty Sure This...
Asked by Cmc76
P0128 - Engine Not Getting Up To Temperature
Replaced The Thermostat, Vacuum Filled The System With New Motorcraft Coolant, And Replaced The Cylinder Head Temperature Sensor. Using An...
Asked by slothy
1/2" Hole In Edelbrock Performer Head
Hi,
I've Been Following The "how To Build A Bbc" Series As I'm Building My Own Iv 454. It's Been Invaluable To Me, So...
Asked by Jonathon67
Cylinder Head Re-installation Instructions Needed?
I Had My Cylinder Head Rebuilt And Need Instructions On How To Put It Back Together. It Is A Natural Gas Fueled Vehicle.
Asked by Jay T Frandsen
1994 Eagle Vision Engine Cooling
I Am Trying To Run Test To Figure Out Why My Vision Is Heating Up. Hopefully I Didn't Warp A Head Or Blow A Head Gasket. Could You...
Asked by DaBulls
