REPLACE/REMOVE CAMSHAFT SENSOR Questions
Spark
Ok The Truck Just Quit Running Going Down The Freeway I Have Replaced The Crank Position Sensor, The Cam Position Sensor, The Distributor...
Asked by chevyman65
P0340 Cam Senor Replaced Both Senor Strats And Runs...
P0340 Cam Senor Replaced Both Senor Strats And Runs Good Engine Light On Same Code?
Asked by Anonymous
I Have A 96 Dodge Ram 1500 4x4 5.9 Liter. It Ios...
I Have A 96 Dodge Ram 1500 4x4 5.9 Liter. It Ios Dumping Fuel And Flooding Out. I Have Changed The Fuel Modual, Aic, Cam Sensor, And Relay...
Asked by Anonymous
1996 Dodge Intrepid Vehicle Isn.t Getting Any Fire
I Parked It One Night And Would Not Start Next Morning.it Isn,t Getting Any Fire To The Spark Plugs.it Will Crank Over Good And I Have...
Asked by metcalf405
Cam Sensor Went Out.l Replaced It .still Dont Start...
Cam Sensor Went Out.l Replaced It .still Dont Start...???? Any Ldeas. How Do U Reset If Thats The Problem???
Asked by Anonymous
CAMSHAFT POSITION SENSOR Power?
I Have A Caravan 2001 4 Cilinders I Change The Coil And The Camshaft Position Sensor And Spark 2 3 Works And 1 And 4 No Electricity Goes In...
Asked by jorgemechan
1997 Dodge Intrepid Cam Sensor
1997 Dodge Intrepid V8 Four Wheel Drive Automatic
I Have Replaced The Cam Sensor In My 1997 Dodge Intrepid 2 Times Randomly 3 Months...
Asked by pag1128
Van Has 3.4 V6. Had Recent Tuneup. Problem Just Began...
Van Has 3.4 V6. Had Recent Tuneup. Problem Just Began. Runs Fine When Cold, But Once Warmed Up, Sputters, Backfires (blew Open Muffler As...
Asked by Anonymous
Cam Shafts And Cam Position Sensors
I Have A 2011 Kia Sorento Lx 3.5, And I Took It To A Shop And Was Told That The Cam Position Sensors Are Bad And Need To Be Changed, So I...
Asked by Nigelg85
1991 Dodge Dynasty Fuel Shut Down
I Have A 91 Dodge Dynasty That Seems To Be Starving For Fuel. When You Energize The Pump A Couple Of Times The Car Will Start And Run For...
Asked by GeneralGOB
