[b:2db49123d1]looking for some tips on how to change the crankshaft position sensor, i know where it is just cant get to it. [/b:2db49123d1]
Apr 2, 2006 at 11:23 AM
crankshaft sensor
SATURN
WHITEY
- MEMBER
- 1 POST
Advertisement
PEPPERMRJ
- ✓ASE Certified Mechanic
- 1,158 POSTS
Piece of cake. :roll:
Just do it by feel from underneath, behind the starter. It helps to have skinney long fingers or a friend that does. Replace the O-ring and put a little vaseline on it before installation. Check your Pms.
Good luck and let us know how it goes. :)
Just do it by feel from underneath, behind the starter. It helps to have skinney long fingers or a friend that does. Replace the O-ring and put a little vaseline on it before installation. Check your Pms.
Good luck and let us know how it goes. :)
Apr 2, 2006 at 2:31 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.