Intake manifold

CHEVROLET CAMARO
Avatar
WALKERZ
  • MEMBER
  • 2 POSTS
I just replaced my intake manifold on my 92' camaro. The replacement is a 93' model and is cast iron instead of the stock aluminum. It runs great but I noticed a loss in power right away. Could it be the timing or vacum lines? Thanks!
Feb 26, 2007 at 10:49 AM
Advertisement
Avatar
RASMATAZ
  • ✓ASE Certified Mechanic
  • 75,992 POSTS
  • ASE Certified Mechanic
Lost of power can be anything within the vehicle.

Last major tune-up done?
Feb 28, 2007 at 12:39 PM
Avatar
WALKERZ
  • MEMBER
  • 2 POSTS
Ok, what if i wan't to do things on my own. How would I go about this tune up (details) and checking.

It means changing the plugs/wires/cap/rotor/pcv valve/fuel filter/air filter/oxygen sensor/and pulling the codes from the computer to get in the mind of the engine management system.
Feb 28, 2007 at 1:32 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.