BRAKE CALIBER

BUICK LESABRE
Avatar
MAINE
  • MEMBER
  • 1 POST
I OWN A '92 BUICK LASABRE, 210,000 MILES, 3800. IM REPLACING THE ROTORS AND PADS AND NOW THAT IM RECONNECTING EVERYTHING THE PIN THAT GOES THRU THE CALIBER WONT SCREW ALL THE WAY THRU! WHATS HOLDING UP THE PIN FROM SCREWING ALL THE WAY THRU?
Nov 29, 2007 at 10:04 AM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
DENNYP
  • AUTOMOTIVE REPAIR CONTRIBUTOR
  • 1,824 POSTS
debris stuck in the caliper mount,where the bolt goes in.Some of these bolts have a small rubber piece on the end of them,so I would suspect that also.
Dec 3, 2007 at 6:52 PM
Advertisement