Engine will not stay running

2003 CHEVROLET SILVERADO
155,000 MILES • 8.1L • V8 • 4WD • AUTOMATIC
Avatar
LOUD PELLETIER
  • MEMBER
  • 39 POSTS
I have an 8.1 vortec and when I come to start it it crank and running rough and shut off 2-3 time and after it starts normally 2 seconds. But if I leave the key in the on position and pump the accelerator pedal 10 time he starts at the quarter of a turn but he won’t stay running after 2 seconds he stop. And the pump is functional, the relays are tested, the spark plugs are new, fuel regulator are tested and I have no fuel level and I put 25 liter of gasoline and I have no fuel level in my cluster and no voltage indicator even if my battery is new but my cluster are rebuild by a pro.
Aug 15, 2021 at 1:02 PM
Advertisement
Avatar
JACOBANDNICKOLAS
  • Experienced Mechanic
  • 110,240 POSTS
Hi,

Have you tested the ignition relay? When the key is in the start or run position, the ignition relay sends power to the following fuses:

- PCM 1
- ETC/ECM
- INJ 1
- INJ 2

If the relay is going bad, you will lose power to the aforementioned components and the vehicle will shut down.

I attached the steps for testing the ignition relay system. Take a look through them and let me know if you find anything helpful.

Also, have you scanned the computer for diagnostic trouble codes? If not, you should.

Here is a video showing how it's done:

https://youtu.be/b2IJGfImVvw

IF you already have done that, let me know if any codes were found.

Let me know.

Joe

Aug 16, 2021 at 1:54 PM
Join 2CarPros for free, one of the most advanced car repair communities on the internet. From first-time drivers to seasoned mechanics, everyone is welcome to reply, share details, and get better answers. You can add a temporary image or video first; uploads are limited to 20 MB.
Ask a Free Question
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.