Air conditioner not working

Well obviously, there is a problem with the A/C system if your getting warm air. The problem may be in the temperature controls.

The temp in that vehicle is controlled by a blend door that regulates heated air flow. It is operated by an electric motor/actuator. The problem can be that the actuator is stripped or inoperative or the door itself could be damaged. This is what needs to be determined by examining the actuator and see if it is responding to heat change commands or not.

The LH temperature blend door actuator can be accessed from below the LH side of the instrument panel.

Hello,

This is what happens when the temperature blend door actuator goes bad. Here is a guide to help walk you through the steps and the location of the actuator for you car below.

https://www.2carpros.com/articles/replace-blend-door-motor

Check out the diagrams (Below). Please let us know if you need anything else to get the problem fixed.

Do you happen to have a gauge set that can give you the low and high side pressures? That is good that we know there are no leaks due to it holding a vacuum but we need to find out if the system is full.

I assume it is full and if the compressor is running but no cold air then the compressor has failed. However, let's start with the pressures because it may just be low. The pressures will tell us if the compressor is creating the pressure difference that is needed and we will quickly find out if the compressor is faulty. Thanks

https://www.2carpros.com/articles/re-charge-an-air-conditioner-system