The car was still running but I wasn't going anywhere?

Tiny
ELEANORM
  • MEMBER
  • 2006 CHRYSLER SEBRING
  • 4 CYL
  • 2WD
  • AUTOMATIC
  • 122,000 MILES
I was driving kinda slow about to turn, and I pushed on the gas and it did nothing, the car was still running but I wasn't going anywhere. Now it won't start. Its throwing out p0340. But we changed all the sensors, and its not the fuel pump. We don't know what else to do, we have tried everything.
Thursday, July 31st, 2014 AT 2:16 PM

1 Reply

Tiny
DANNY L
  • MECHANIC
  • 5,648 POSTS
Hello, I'm Danny.

Here is the information you requested. Code P0340 is a camshaft position sensor fault code. Here is a tutorial showing how to replace a camshaft sensor:

https://www.2carpros.com/articles/camshaft-angle-sensor-replacement

You will need to check some electrical circuits for this code so here is a tutorial showing how to test electrical wiring.

https://www.2carpros.com/articles/how-to-check-wiring

I've attached a diagnostic picture flow chart below for code P0340 on your Sebring. I've also attached below the picture steps on replacing the camshaft position sensor including its location. Hope this helps and thanks for using 2CarPros.
Was this
answer
helpful?
Yes
No
Tuesday, September 14th, 2021 AT 5:43 AM

Please login or register to post a reply.

Sponsored links