start up ticking noise

2004 FORD F-150
200,000 MILES • V8 • 4WD • AUTOMATIC
Avatar
CPTTPD360
  • MEMBER
  • 4 POSTS
replace vct phaser kit 2004 5.4 triton
Dec 19, 2010 at 6:27 PM
Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.
Advertisement
Avatar
MJR346
  • CAR REPAIR CONTRIBUTOR
  • 132 POSTS
Normally it will tick when first started on these espcially after changing the phaser kit.. but make sure the oil passages are clean.. there is one in the cam cap that needs to be cleaned as well as right oil and Ford recommends their filter for noise issues also
Dec 19, 2010 at 7:08 PM
Advertisement
Avatar
CPTTPD360
  • MEMBER
  • 4 POSTS
how do you change the vct phaser kit on a 2004 5.4 triton f-150
Dec 19, 2010 at 10:42 PM
Avatar
MJR346
  • CAR REPAIR CONTRIBUTOR
  • 132 POSTS
Basically involves pulling the valve covers and the front cover off the motor if you don't have the special Ford tool to hold the timing chain in place while you remove and install a new cam gear using a special bolt that has to be tightened a specific way. Not some I recommend to people unless pro techs or very advanced DIYers
Dec 20, 2010 at 1:54 AM