Blower motor resistor location needed

2004 DODGE STRATUS

200,000 MILES • 4 CYL • 2WD • AUTOMATIC

16RUBGA

MEMBER
1 POST

Car listed above is the SXT model. I cannot find the resistor on this vehicle to change it out. Can someone educate me on what's going on here? Please watch video.

Jul 10, 2020 at 1:31 PM

ASEMASTER6371

✓ASE Certified Mechanic
52,796 POSTS

Good afternoon,

There is no video attached. Can you please reload it to this post?

The blower resistor is in the heater housing under the right side of the dash by the blower motor.

Roy

REMOVAL
1. Remove lower right silencer panel.

Resistor Block
imageOpen In New TabZoom/Print

2. Disconnect wiring connectors from resistor.
3. Remove blower resistor mounting screws.
4. Pull blower motor resistor out of HVAC housing.

INSTALLATION
1. Install blower resistor into HVAC housing.
2. Install and tighten the two resistor mounting screws.
3. Connect resistor wiring harness.
4. Install right silencer pane

Image (Click to enlarge)

Professional Diagram for 2CarPros Members
Click here to log in and view diagram.

Jul 10, 2020 at 2:48 PM

16RUBGA

MEMBER
1 POST

That is not what the under side of the dash looks like?

Jul 13, 2020 at 7:37 PM

ASEMASTER6371

✓ASE Certified Mechanic
52,796 POSTS

Okay, can you upload the video to show me what it does look like?

I need to see what you see.

Roy

Jul 14, 2020 at 3:51 AM

Repair Safety Notice: This information is for general instructional purposes only. Vehicle repair can be dangerous. Verify all information, follow manufacturer service procedures, use proper tools and safety equipment, and consult a qualified repair shop when needed.