Engine cylinder misfires?

Tiny
MHPAUTOS
  • MECHANIC
  • 31,937 POSTS
Hi there,

replace the fuel filter and check fuel for contamination. Have fuel rail pressure test done, this will help pick up a faulty (leaking) injector. Have the engine electrics checked running on an oscilloscope, this will help diagnose any ignition faults, check for any fault codes as well.

Mark (mhpautos)
Was this
answer
helpful?
Yes
No
Monday, January 11th, 2021 AT 5:53 PM (Merged)
Tiny
HAWAII-FIVE-0
  • MEMBER
  • 2 POSTS
Thanks for the help. I did a "drop test" and found one cylinder bad, changed the coil pack and fixed the problem.
For thoes that would liek to know how.
With your car started start pulling the plug to your coil pack one at a time. You should hear your engine start to die. If you dont hear any change in engine idle that cilinder is the problem. Continue to all cylinders to make sure its only one cylinder. From there you have the plug, the coil pack, and the wire. If your plugs look good change the pack its $90 from honda.
This worked for me on my 2000 accord V6.

Thanks
Was this
answer
helpful?
Yes
No
+1
Monday, January 11th, 2021 AT 5:53 PM (Merged)
Tiny
CDABBYMOM
  • MEMBER
  • 1 POST
  • 2000 HONDA ACCORD
I have an Accord with 188,000 that just started acting up. The check engine light came on and started blinking. When I pulled the codes I got 5 - P0300, P0303, P0304, P0306 & P1399.
The car had it's timing belt, altinator, battery & plugs changed last year. The car is ideling something awful and you can smell gas. The dealership recommended replacing the coils. Can the 3 coils go bad at the same time? Is there one coil for each spark plug?
Thanks!
Was this
answer
helpful?
Yes
No
Monday, January 11th, 2021 AT 5:53 PM (Merged)
Tiny
BRUCE HUNT
  • MECHANIC
  • 3,754 POSTS
Yes there is one for each cylinder and I am at a loss for how or why 3 would fail at the same time. They range from $46 a piece on up. They aren't that difficult to replace. It is highly likely this WILL fix the problems but. Maybe you could trying replacing one of the suspected bad ones, clear the codes, see if it runs a little bit better and that when the codes reappear that the one you replaced drops off. If not, you have problem further upstream. Just a thought versus jumping out a replacing them all at once.
Was this
answer
helpful?
Yes
No
+1
Monday, January 11th, 2021 AT 5:53 PM (Merged)

Please login or register to post a reply.

Sponsored links