SPONSORED LINKS

Have 2 quick ones ! Looking for transfer case to trans gasket & have crankshaft issue.

Tiny
SKINNERBOY 101
  • MEMBER
  • 2000 GMC JIMMY
  • 207,000 MILES
I having to pull the moter to rebuild due to crankshaft end play is almost 3/8 of an inch and it has been making a horible sqealing sound and when you push the crankshaft in it stops ! Never seen this ever. Lol. Second I need to replace the transfer case to trans gasket but dont know where to but or start to look for?What would cause a crank to fail like that? Never in my life have I seen this and I hope the conecting rods are not hurt from all the movement. Any sugestions or guidence will be greatly appreciated =)

thanks
douglas
SPONSORED LINKS
Tuesday, November 15th, 2011 AT 5:43 AM

2 Replies

Tiny
RASMATAZ
  • MECHANIC
  • 75,992 POSTS
Check the thrust bearing could be worned out causing the excessive play
Was this
answer
helpful?
Yes
No
Tuesday, November 15th, 2011 AT 5:50 AM
Tiny
JACOBANDNICKOLAS
  • MECHANIC
  • 109,885 POSTS
That is from normal wear. The rods should be fine, but make sure you replace bearings. As far as gasket, you should be able to get one at a parts store. They may have to order it, but should be able to get it. If they can't a dealer will have one or you could contact a trans shop and get one from them.
SPONSORED LINKS
Was this
answer
helpful?
Yes
No
Tuesday, November 15th, 2011 AT 5:50 AM

Please login or register to post a reply.

Related Crankshaft Replace/Remove Content

VIEW MORE

Sponsored links