Possible bad blower motor?

Tiny
DM91266
  • MEMBER
  • 1999 FORD CROWN VICTORIA
  • V8
  • 2WD
  • AUTOMATIC
  • 149,000 MILES
Blower motor in 1999 Ford Crown Victoria Police Interceptor not working. Defrost, fan speed set on high, temperature **** set at Hot, to heat coming through the air vents. Possible bad blower motor? I can hear the brushes of the fan spin when forced heat from engine going through heater core, and into blower motor. Any advice would greatly appreciated.
Tuesday, December 7th, 2010 AT 8:37 PM

7 Replies

Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
Is the blow working? Your not clear on that.
Was this
answer
helpful?
Yes
No
Tuesday, December 7th, 2010 AT 8:48 PM
Tiny
DM91266
  • MEMBER
  • 4 POSTS
The blower motor does not work on low, medium or high fan speed. It seems when I drive the car, I put my hand up by the defrost vents by the windshield, and can feel just a little heat but not enough heat to be blown through if it was on low. I have to tap the blower motor under the dash to get it going, but hardly works at all.
Was this
answer
helpful?
Yes
No
Tuesday, December 7th, 2010 AT 9:01 PM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
Ok, you have a bad blower motor then.
Was this
answer
helpful?
Yes
No
Tuesday, December 7th, 2010 AT 9:03 PM
Tiny
DM91266
  • MEMBER
  • 4 POSTS
Is it difficult to replace? I located a good used blower motor at a local salvage yard for $35.00 It has to be located behind the glove box (passenger side) under the dash with possibly 4 bolts holding it in place. Is this correct? Thank you
Was this
answer
helpful?
Yes
No
Tuesday, December 7th, 2010 AT 9:06 PM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
Yes, it's not hard to change but I certainly would put a used one in. That's nearly as much as a new one. Yours is in the engine compartment.
Was this
answer
helpful?
Yes
No
Tuesday, December 7th, 2010 AT 9:09 PM
Tiny
DM91266
  • MEMBER
  • 4 POSTS
Is it located next to the a/c unit on the passenger side firewall? What shape is it so I know what to look for. Thanks so much Been very helpful
Was this
answer
helpful?
Yes
No
Tuesday, December 7th, 2010 AT 9:13 PM
Tiny
WRENCHTECH
  • MECHANIC
  • 20,761 POSTS
View below image
Was this
answer
helpful?
Yes
No
Tuesday, December 7th, 2010 AT 9:14 PM

Please login or register to post a reply.

Sponsored links